[PATCH 04/13] power: supply: bq25890: Fix initial setting of the F_CONV_RATE field

[Hans de Goede]

The code doing the initial setting of the F_CONV_RATE field based
on the bq->state.online flag. In order for this to work properly,
this must be done after the initial bq25890_get_chip_state() call.

Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
 drivers/power/supply/bq25890_charger.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/power/supply/bq25890_charger.c b/drivers/power/supply/bq25890_charger.c
index 491d36a3811a..99497fdc73da 100644
--- a/drivers/power/supply/bq25890_charger.c
+++ b/drivers/power/supply/bq25890_charger.c
@@ -682,16 +682,16 @@ static int bq25890_hw_init(struct bq25890_device *bq)
 		}
 	}
 
-	/* Configure ADC for continuous conversions when charging */
-	ret = bq25890_field_write(bq, F_CONV_RATE, !!bq->state.online);
+	ret = bq25890_get_chip_state(bq, &bq->state);
 	if (ret < 0) {
-		dev_dbg(bq->dev, "Config ADC failed %d\n", ret);
+		dev_dbg(bq->dev, "Get state failed %d\n", ret);
 		return ret;
 	}
 
-	ret = bq25890_get_chip_state(bq, &bq->state);
+	/* Configure ADC for continuous conversions when charging */
+	ret = bq25890_field_write(bq, F_CONV_RATE, !!bq->state.online);
 	if (ret < 0) {
-		dev_dbg(bq->dev, "Get state failed %d\n", ret);
+		dev_dbg(bq->dev, "Config ADC failed %d\n", ret);
 		return ret;
 	}
 
-- 
2.31.1