[PATCH v4 2/3] dt-bindings: hwmon: ti,ina2xx: Add ti,shunt-gain property

[Nathan Rossi]

From: Nathan Rossi <nathan.rossi@xxxxxxxx>

Add a property to the binding to define the selected shunt voltage gain.
This specifies the range and accuracy that applies to the shunt circuit.
This property only applies to devices that have a selectable shunt
voltage range via PGA or ADCRANGE register configuration.

Signed-off-by: Nathan Rossi <nathan.rossi@xxxxxxxx>
---
Changes in v2:
- Added binding for shunt-gain

Changes in v3:
- Fix schema error, setting $ref to uint32
- Improve the description to detail exactly how to define the property
  and how the property affects initial device configuration and
  calculation of values
---
 .../devicetree/bindings/hwmon/ti,ina2xx.yaml        | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml b/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
index 180573f26c..47af97bb4c 100644
--- a/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
+++ b/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
@@ -36,6 +36,27 @@ properties:
       Shunt resistor value in micro-Ohm.
     $ref: /schemas/types.yaml#/definitions/uint32
 
+  ti,shunt-gain:
+    description: |
+      Programmable gain divisor for the shunt voltage accuracy and range. This
+      property only applies to devices that have configurable PGA/ADCRANGE. The
+      gain value is used configure the gain and to convert the shunt voltage,
+      current and power register values when reading measurements from the
+      device.
+
+      For devices that have a configurable PGA (e.g. INA209, INA219, INA220),
+      the gain value maps directly with the PG bits of the config register.
+
+      For devices that have ADCRANGE configuration (e.g. INA238) a shunt-gain
+      value of 1 maps to ADCRANGE=1 where no gain divisor is applied to the
+      shunt voltage, and a value of 4 maps to ADCRANGE=0 such that a wider
+      voltage range is used.
+
+      The default value is device dependent, and is defined by the reset value
+      of PGA/ADCRANGE in the respective configuration registers.
+    $ref: /schemas/types.yaml#/definitions/uint32
+    enum: [1, 2, 4, 8]
+
 required:
   - compatible
   - reg
---
2.33.0