[PATCH 5.4 018/355] media: ite-cir: IR receiver stop working after receive overflow

[Greg Kroah-Hartman]

From: Sean Young <sean@xxxxxxxx>

commit fdc881783099c6343921ff017450831c8766d12a upstream.

On an Intel NUC6iSYK, no IR is reported after a receive overflow.

When a receiver overflow occurs, this condition is only cleared by
reading the fifo. Make sure we read anything in the fifo.

Fixes: 28c7afb07ccf ("media: ite-cir: check for receive overflow")
Suggested-by: Bryan Pass <bryan.pass@xxxxxxxxx>
Tested-by: Bryan Pass <bryan.pass@xxxxxxxxx>
Cc: stable@xxxxxxxxxxxxxxx>
Signed-off-by: Sean Young <sean@xxxxxxxx>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
 drivers/media/rc/ite-cir.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

--- a/drivers/media/rc/ite-cir.c
+++ b/drivers/media/rc/ite-cir.c
@@ -283,7 +283,7 @@ static irqreturn_t ite_cir_isr(int irq,
 	}
 
 	/* check for the receive interrupt */
-	if (iflags & ITE_IRQ_RX_FIFO) {
+	if (iflags & (ITE_IRQ_RX_FIFO | ITE_IRQ_RX_FIFO_OVERRUN)) {
 		/* read the FIFO bytes */
 		rx_bytes =
 			dev->params.get_rx_bytes(dev, rx_buf,