[PATCH v1 3/4] ARM: dts: imx6qdl-vicut1: add CAN termination support

[Oleksij Rempel]

The gpio1 0 pin is controlling CAN termination, not USB H1 VBUS. So,
remove wrong regulator and assign this GPIO to the new DT CAN termination
property.

Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
 arch/arm/boot/dts/imx6qdl-vicut1.dtsi | 12 ++----------
 1 file changed, 2 insertions(+), 10 deletions(-)

diff --git a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
index b9e305774fed..1ac7e13249d2 100644
--- a/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-vicut1.dtsi
@@ -126,15 +126,6 @@ reg_3v3: regulator-3v3 {
 		regulator-max-microvolt = <3300000>;
 	};
 
-	reg_h1_vbus: regulator-h1-vbus {
-		compatible = "regulator-fixed";
-		regulator-name = "h1-vbus";
-		regulator-min-microvolt = <5000000>;
-		regulator-max-microvolt = <5000000>;
-		gpio = <&gpio1 0 GPIO_ACTIVE_HIGH>;
-		enable-active-high;
-	};
-
 	reg_otg_vbus: regulator-otg-vbus {
 		compatible = "regulator-fixed";
 		regulator-name = "otg-vbus";
@@ -212,6 +203,8 @@ IMX_AUDMUX_V2_PTCR_SYN		IMX_AUDMUX_V2_PDCR_RXDSEL(0)
 &can1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_can1>;
+	termination-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>;
+	termination-ohms = <150>;
 	status = "okay";
 };
 
@@ -492,7 +485,6 @@ &uart5 {
 };
 
 &usbh1 {
-	vbus-supply = <&reg_h1_vbus>;
 	pinctrl-names = "default";
 	phy_type = "utmi";
 	dr_mode = "host";
-- 
2.30.2