[PATCH RFC v2 2/4] dt-bindings: phy: ti,tcan104x-can: Document mux-controls property

[Aswath Govindraju]

On some boards, for routing CAN signals from controller to transceivers,
muxes might need to be set. Use mux-controls property can be used for model
this.

Signed-off-by: Aswath Govindraju <a-govindraju@xxxxxx>
---
 .../devicetree/bindings/phy/ti,tcan104x-can.yaml          | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
index 6107880e5246..7392088cf060 100644
--- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
+++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
@@ -37,6 +37,13 @@ properties:
       max bit rate supported in bps
     minimum: 1
 
+  mux-controls:
+    description:
+      mux controller node to route the signals from controller to
+      transceiver. The first and second arguments can be used
+      representing the line in the mux-controller to control and
+      the state to be set in the given line respectively.
+
 required:
   - compatible
   - '#phy-cells'
@@ -53,4 +60,5 @@ examples:
       max-bitrate = <5000000>;
       standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>;
       enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>;
+      mux-controls = <&mux0 0 1>;
     };
-- 
2.17.1