Re: [PATCH 1/3] ALSA: hda/tegra: Skip reset on BPMP devices

[Dmitry Osipenko]

14.12.2021 10:22, Sameer Pujar пишет:
...
>>> How the reset behavior is different? At this point when HDA driver is
>>> loaded the HW is already reset during display ungate. What matters,
>>> during HDA driver load, is whether the HW is in predictable state or not
>>> and the answer is yes. So I am not sure what problem you are referring
>>> to. Question is, if BPMP already ensures this, then why driver needs to
>>> take care of it.
>> 1. Enable display
>> 2. Play audio over HDMI
> 
>> 3. HDA hardware now is in dirty state
> 
> Why this would be a dirty state? It is rather a functional state. Isn't
> it? Power-domain is ON while all this happens.

In general state should be a functional, but we shouldn't assume that.
There is always a possibility for a subtle bug in a driver that may put
h/w into a bad state. Full hardware reset is encouraged by users.

> Another point is, with present logic the reset is not applied for every
> runtime PM resume of HDA device, which is confusing. It depends on the
> state of 'chip->running' flag and I don't see this getting cleared
> anywhere. Would you say subsequent HDA playback happen under a dirty state?

This is a good point. There should be another potential problem in the
HDA driver for newer SoCs because apparently we don't re-initialize HDA
controller properly after runtime PM resume.

See hda_tegra_first_init() that is invoked only during driver probe, it
configures FPCI_DBG_CFG_2 register on T194, which isn't done by
hda_tegra_init(), and thus, this register may be  in reset state after
resume from RPM suspend. It should be a bug in the HDA driver that needs
to be fixed.

On older SoCs: HDA resides in the APB power domain which could be
disabled only across system suspend/resume. HDA is only clock-gated
during runtime PM suspend.

On newer SoCs: HDA power state could be lost after RPM suspend/resume,
depending on the state of display. I'm wondering whether HDMI playback
works after DPMS on T194+, I assume this case was never tested properly.

It looks like it should be safe to reset HDA on runtime PM resume
regardless of the chip->running, and thus, we could remove that check
and reset HDA unconditionally. Will great if you could check/test and
improve this in the driver.

I'm also wondering whether snd_power_change_state() should be moved into
RPM callbacks and whether this function does anything practically useful
on Tegra at all.