Re: [PATCH V4 0/5] the UART driver compatible with

[Yu Tu]

Hi Neil,
	Thank you very much for your reply.

On 2022/1/10 17:27, Neil Armstrong wrote:
> [ EXTERNAL EMAIL ]
>
> Hi,
>
> On 10/01/2022 09:55, Yu Tu wrote:
> > Using the common Clock code to describe the UART baud rate
> > clock makes it easier for the UART driver to be compatible
> > with the baud rate requirements of the UART IP on different
> > meson chips. Add Meson S4 SoC compatible.
> >
> > Yu Tu (5):
> >    dt-bindings: serial: meson: Drop compatible = amlogic,meson-gx-uart.
> >    tty: serial: meson: Request the register region in meson_uart_probe()
> >    tty: serial: meson: The UART baud rate calculation is described using
> >      the common clock code.
> >    tty: serial: meson: Make the bit24 and bit [26,27] of the UART_REG5
> >      register writable
> >    tty: serial: meson: Added S4 SOC compatibility.
>
> Weird, the subjects are fine in the cover letter but are all truncated in the email thread:
> [PATCH V4 0/5] the UART driver compatible with
> [PATCH V4 1/5] dt-bindings: serial: meson: Drop
> [PATCH V4 2/5] tty: serial: meson: Request the register
> ...
> Only the last one is OK.
I saw the subject was a little long, I changed it manually, do I need to 
regenerate and send?
> > V1 -> V2: Use CCF to describe the UART baud rate clock.Make some changes as
> > discussed in the email
> > V2 -> V3: add compatible = "amlogic,meson-gx-uart". Because it must change
> > the DTS before it can be deleted
> > V3 -> V4: Change CCF to describe the UART baud rate clock as discussed
> > in the email.
> >
> > Link:https://lore.kernel.org/linux-amlogic/20211230102110.3861-4-yu.tu@xxxxxxxxxxx/
> >
> >   .../bindings/serial/amlogic,meson-uart.yaml   |  10 +-
> >   drivers/tty/serial/meson_uart.c               | 244 ++++++++++++------
> >   2 files changed, 177 insertions(+), 77 deletions(-)