Re: [PATCH v2] selftests: rtc: Increase test timeout so that all tests run

[Shuah Khan]

On 1/12/22 1:22 PM, Alexandre Belloni wrote:
> On 12/01/2022 14:41:42-0500, Nícolas F. R. A. Prado wrote:
> > The timeout setting for the rtc kselftest is currently 90 seconds. This
> > setting is used by the kselftest runner to stop running a test if it
> > takes longer than the assigned value.
> >
> > However, two of the test cases inside rtc set alarms. These alarms are
> > set to the next beginning of the minute, so each of these test cases may
> > take up to, in the worst case, 60 seconds.
> >
> > In order to allow for all test cases in rtc to run, even in the worst
> > case, when using the kselftest runner, the timeout value should be
> > increased to at least 120. Set it to 180, so there's some additional
> > slack.
> >
> > Correct operation can be tested by running the following command right
> > after the start of a minute (low second count), and checking that all
> > test cases run:
> >
> > 	./run_kselftest.sh -c rtc
> >
> > Signed-off-by: Nícolas F. R. A. Prado <nfraprado@xxxxxxxxxxxxx>
> Acked-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx>

Thank you both. Will apply this for 5.17-rc2 once the merge window
closes.

thanks,
-- Shuah