[PATCH 1/4] dt-bindings: usb: usb-nop-xceiv: Repurpose vbus-regulator

[Sean Anderson]

The vbus-regulator property was never actually read from the device tree.
Introduce a new property vbus-supply to represent the regulator powering
the VBUS when acting as an A-Device. This supply will be enabled and
disabled as necessary. Note that this is different from vbus-regulator,
which represented the available current available to draw from VBUS in
B-Device mode. Because no one was using vbus-regulator, remove it.

Signed-off-by: Sean Anderson <sean.anderson@xxxxxxxx>
---

 Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml
index 2824c17285ee..a79459bb5a4c 100644
--- a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml
+++ b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.yaml
@@ -34,9 +34,9 @@ properties:
     description: Should specify the GPIO detecting a VBus insertion
     maxItems: 1
 
-  vbus-regulator:
-    description: Should specifiy the regulator supplying current drawn from
-      the VBus line.
+  vbus-supply:
+  description: regulator supplying VBUS. It will be enabled and disabled
+               dynamically in OTG mode.
     $ref: /schemas/types.yaml#/definitions/phandle
 
 required:
@@ -57,7 +57,7 @@ examples:
         vcc-supply = <&hsusb1_vcc_regulator>;
         reset-gpios = <&gpio1 7 GPIO_ACTIVE_LOW>;
         vbus-detect-gpio = <&gpio2 13 GPIO_ACTIVE_HIGH>;
-        vbus-regulator = <&vbus_regulator>;
+        vbus-supply = <&vbus_regulator>;
         #phy-cells = <0>;
     };
 
-- 
2.25.1