Re: [PATCH v2 3/4] irqchip/meson-gpio: add select trigger type callback

[Neil Armstrong]

Hi,

On 19/01/2022 08:08, Qianggui Song wrote:
> Due to some chips may use different registers and offset, provide
> a set trigger type call back.
> 
> Signed-off-by: Qianggui Song <qianggui.song@xxxxxxxxxxx>
> ---
>  drivers/irqchip/irq-meson-gpio.c | 8 ++++++++
>  1 file changed, 8 insertions(+)
> 
> diff --git a/drivers/irqchip/irq-meson-gpio.c b/drivers/irqchip/irq-meson-gpio.c
> index eefe15e1b3a6..b511f9532adc 100644
> --- a/drivers/irqchip/irq-meson-gpio.c
> +++ b/drivers/irqchip/irq-meson-gpio.c
> @@ -55,6 +55,8 @@ struct irq_ctl_ops {
>  	void (*gpio_irq_sel_pin)(struct meson_gpio_irq_controller *ctl,
>  				 unsigned int channel, unsigned long hwirq);
>  	void (*gpio_irq_init)(struct meson_gpio_irq_controller *ctl);
> +	void (*gpio_irq_sel_type)(struct meson_gpio_irq_controller *ctl,
> +				  unsigned int idx, u32 val);
>  };
>  
>  struct meson_gpio_irq_params {
> @@ -278,6 +280,12 @@ static int meson_gpio_irq_type_setup(struct meson_gpio_irq_controller *ctl,
>  	 */
>  	type &= IRQ_TYPE_SENSE_MASK;
>  
> +	/* Some controllers may have different calculation method*/
> +	if (params->ops.gpio_irq_sel_type) {
> +		params->ops.gpio_irq_sel_type(ctl, idx, type);
> +		return 0;
> +	}
> +
>  	/*
>  	 * New controller support EDGE_BOTH trigger. This setting takes
>  	 * precedence over the other edge/polarity settings
> 

The comment on v1 hasn't been addresses here, it was asked to move the old controllers
sel_type to a callback and introduce an S4 callback instead of doing this.

Neil