Re: [PATCH 01/16] scsi: libsas: Use enum for response frame DATAPRES field

[Jinpu Wang]

On Tue, Jan 25, 2022 at 12:38 PM John Garry <john.garry@xxxxxxxxxx> wrote:
>
> As defined in table 126 of the SAS spec 1.1, use an enum for the DATAPRES
> field, which makes reading the code easier.
>
> Signed-off-by: John Garry <john.garry@xxxxxxxxxx>
Reviewed-by: Jack Wang <jinpu.wang@xxxxxxxxx>
Thx!
> ---
>  drivers/scsi/libsas/sas_task.c | 12 +++++++++---
>  1 file changed, 9 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/scsi/libsas/sas_task.c b/drivers/scsi/libsas/sas_task.c
> index 2966ead1d421..7240fd22b154 100644
> --- a/drivers/scsi/libsas/sas_task.c
> +++ b/drivers/scsi/libsas/sas_task.c
> @@ -7,6 +7,12 @@
>  #include <scsi/sas.h>
>  #include <scsi/libsas.h>
>
> +enum {
> +       NO_DATA = 0,
> +       RESPONSE_DATA = 1,
> +       SENSE_DATA = 2,
> +};
> +
>  /* fill task_status_struct based on SSP response frame */
>  void sas_ssp_task_response(struct device *dev, struct sas_task *task,
>                            struct ssp_response_iu *iu)
> @@ -15,11 +21,11 @@ void sas_ssp_task_response(struct device *dev, struct sas_task *task,
>
>         tstat->resp = SAS_TASK_COMPLETE;
>
> -       if (iu->datapres == 0)
> +       if (iu->datapres == NO_DATA)
>                 tstat->stat = iu->status;
> -       else if (iu->datapres == 1)
> +       else if (iu->datapres == RESPONSE_DATA)
>                 tstat->stat = iu->resp_data[3];
> -       else if (iu->datapres == 2) {
> +       else if (iu->datapres == SENSE_DATA) {
>                 tstat->stat = SAS_SAM_STAT_CHECK_CONDITION;
>                 tstat->buf_valid_size =
>                         min_t(int, SAS_STATUS_BUF_SIZE,
> --
> 2.26.2
>