[PATCH v5 4/4] irqchip/realtek-rtl: use per-parent domains

[Sander Vanheule]

The interrupt router can connect each of its inputs to one of the parent
interrupts. These parent interrupts may be handled differently by their
interrupt controller. SoC interrupts should be treated per-parent, to
maintain this expected behaviour for routed child interrupts.

For example, it is possible that both networking interrupts and the
system event timer interrupts are routed through this controller. Even
under high network load, event timer interrupts should take precedence,
which can be ensured by routing them to a higher priority parent.

Rework the driver to use a separate domain for each output, using all
available parents interrupts (as specified in the devicetree). A
per-parent mask of child interrupts is used to keep track of which
domain should handle which interrupts.

Signed-off-by: Sander Vanheule <sander@xxxxxxxxxxxxx>
---
Changes since v4:
- Use irq_domain_add_linear instead of irq_domain_add_simple
- Drop 'inline' specifiers from static functions
- Drop WARN in intc_select() to only warn once for old bindings

 drivers/irqchip/irq-realtek-rtl.c | 149 +++++++++++++++++++++++++-----
 1 file changed, 124 insertions(+), 25 deletions(-)

diff --git a/drivers/irqchip/irq-realtek-rtl.c b/drivers/irqchip/irq-realtek-rtl.c
index 2a349082af81..0cd25e2cb8cc 100644
--- a/drivers/irqchip/irq-realtek-rtl.c
+++ b/drivers/irqchip/irq-realtek-rtl.c
@@ -22,12 +22,22 @@
 #define RTL_ICTL_IRR3		0x14
 
 #define RTL_ICTL_NUM_INPUTS	32
+#define RTL_ICTL_NUM_OUTPUTS	15
 
 #define REG(x)		(realtek_ictl_base + x)
 
 static DEFINE_RAW_SPINLOCK(irq_lock);
 static void __iomem *realtek_ictl_base;
 
+struct realtek_ictl_output {
+	/* IRQ controller data */
+	struct fwnode_handle *fwnode;
+	/* Output specific data */
+	unsigned int output_index;
+	struct irq_domain *domain;
+	u32 child_mask;
+};
+
 /*
  * IRR0-IRR3 store 4 bits per interrupt, but Realtek uses inverted numbering,
  * placing IRQ 31 in the first four bits. A routing value of '0' means the
@@ -37,6 +47,11 @@ static void __iomem *realtek_ictl_base;
 #define IRR_OFFSET(idx)		(4 * (3 - (idx * 4) / 32))
 #define IRR_SHIFT(idx)		((idx * 4) % 32)
 
+static u32 read_irr(void __iomem *irr0, int idx)
+{
+	return (readl(irr0 + IRR_OFFSET(idx)) >> IRR_SHIFT(idx)) & 0xf;
+}
+
 static void write_irr(void __iomem *irr0, int idx, u32 value)
 {
 	unsigned int offset = IRR_OFFSET(idx);
@@ -84,51 +99,128 @@ static struct irq_chip realtek_ictl_irq = {
 
 static int intc_map(struct irq_domain *d, unsigned int irq, irq_hw_number_t hw)
 {
+	struct realtek_ictl_output *output = d->host_data;
 	unsigned long flags;
+	u32 routing_old;
+	int err = 0;
+
+	raw_spin_lock_irqsave(&irq_lock, flags);
+
+	/*
+	 * Inputs can only be routed to one output, so they shouldn't end up in
+	 * multiple domains. Perform this check in the same atomic context as
+	 * configuring the routing to prevent races.
+	 */
+	routing_old = read_irr(REG(RTL_ICTL_IRR0), hw);
+	if (routing_old && output->output_index != routing_old - 1) {
+		pr_err("int %ld already routed to output %d\n",
+			hw, routing_old - 1);
+		err = -EINVAL;
+		goto out;
+	}
+
+	output->child_mask |= BIT(hw);
+	write_irr(REG(RTL_ICTL_IRR0), hw, output->output_index + 1);
 
 	irq_set_chip_and_handler(irq, &realtek_ictl_irq, handle_level_irq);
 
-	raw_spin_lock_irqsave(&irq_lock, flags);
-	write_irr(REG(RTL_ICTL_IRR0), hw, 1);
+out:
 	raw_spin_unlock_irqrestore(&irq_lock, flags);
 
-	return 0;
+	return err;
+}
+
+static int intc_select(struct irq_domain *d, struct irq_fwspec *fwspec,
+	enum irq_domain_bus_token bus_token)
+{
+	struct realtek_ictl_output *output = d->host_data;
+
+	if (fwspec->fwnode != output->fwnode)
+		return false;
+
+	/* Original specifiers only had one parameter */
+	if (fwspec->param_count < 2)
+		return true;
+
+	return fwspec->param[1] == output->output_index;
 }
 
 static const struct irq_domain_ops irq_domain_ops = {
 	.map = intc_map,
+	.select = intc_select,
 	.xlate = irq_domain_xlate_onecell,
 };
 
 static void realtek_irq_dispatch(struct irq_desc *desc)
 {
+	struct realtek_ictl_output *output = irq_desc_get_handler_data(desc);
 	struct irq_chip *chip = irq_desc_get_chip(desc);
-	struct irq_domain *domain;
 	unsigned long pending;
 	unsigned int soc_int;
 
 	chained_irq_enter(chip, desc);
-	pending = readl(REG(RTL_ICTL_GIMR)) & readl(REG(RTL_ICTL_GISR));
+	pending = readl(REG(RTL_ICTL_GIMR)) & readl(REG(RTL_ICTL_GISR))
+		& output->child_mask;
 
 	if (unlikely(!pending)) {
 		spurious_interrupt();
 		goto out;
 	}
 
-	domain = irq_desc_get_handler_data(desc);
-	for_each_set_bit(soc_int, &pending, 32)
-		generic_handle_domain_irq(domain, soc_int);
+	for_each_set_bit(soc_int, &pending, RTL_ICTL_NUM_INPUTS)
+		generic_handle_domain_irq(output->domain, soc_int);
 
 out:
 	chained_irq_exit(chip, desc);
 }
 
+static int __init setup_parent_interrupts(struct device_node *node, int *parents,
+	unsigned int num_parents)
+{
+	struct realtek_ictl_output *outputs;
+	struct realtek_ictl_output *output;
+	struct irq_domain *domain;
+	unsigned int p;
+
+	outputs = kcalloc(num_parents, sizeof(*outputs), GFP_KERNEL);
+	if (!outputs)
+		return -ENOMEM;
+
+	for (p = 0; p < num_parents; p++) {
+		output = outputs + p;
+
+		domain = irq_domain_add_linear(node, RTL_ICTL_NUM_INPUTS,
+						&irq_domain_ops, output);
+		if (!domain)
+			goto domain_err;
+
+		output->fwnode = of_node_to_fwnode(node);
+		output->output_index = p;
+		output->domain = domain;
+
+		irq_set_chained_handler_and_data(parents[p], realtek_irq_dispatch, output);
+	}
+
+	return 0;
+
+domain_err:
+	while (p--) {
+		irq_set_chained_handler_and_data(parents[p], NULL, NULL);
+		irq_domain_remove(outputs[p].domain);
+	}
+
+	kfree(outputs);
+
+	return -ENOMEM;
+}
+
 static int __init realtek_rtl_of_init(struct device_node *node, struct device_node *parent)
 {
+	int parent_irqs[RTL_ICTL_NUM_OUTPUTS];
 	struct of_phandle_args oirq;
-	struct irq_domain *domain;
+	unsigned int num_parents;
 	unsigned int soc_irq;
-	int parent_irq;
+	unsigned int p;
 
 	realtek_ictl_base = of_iomap(node, 0);
 	if (!realtek_ictl_base)
@@ -139,36 +231,43 @@ static int __init realtek_rtl_of_init(struct device_node *node, struct device_no
 	for (soc_irq = 0; soc_irq < RTL_ICTL_NUM_INPUTS; soc_irq++)
 		write_irr(REG(RTL_ICTL_IRR0), soc_irq, 0);
 
-	if (WARN_ON(!of_irq_count(node))) {
+	num_parents = of_irq_count(node);
+	if (num_parents > RTL_ICTL_NUM_OUTPUTS) {
+		pr_err("too many parent interrupts\n");
+		return -EINVAL;
+	}
+
+	for (p = 0; p < num_parents; p++)
+		parent_irqs[p] = of_irq_get(node, p);
+
+	if (WARN_ON(!num_parents)) {
 		/*
 		 * If DT contains no parent interrupts, assume MIPS CPU IRQ 2
 		 * (HW0) is connected to the first output. This is the case for
 		 * all known hardware anyway. "interrupt-map" is deprecated, so
 		 * don't bother trying to parse that.
+		 * Since this is to account for old devicetrees with one-cell
+		 * interrupt specifiers, only one output domain is needed.
 		 */
 		oirq.np = of_find_compatible_node(NULL, NULL, "mti,cpu-interrupt-controller");
 		oirq.args_count = 1;
 		oirq.args[0] = 2;
 
-		parent_irq = irq_create_of_mapping(&oirq);
+		parent_irqs[0] = irq_create_of_mapping(&oirq);
+		num_parents = 1;
 
 		of_node_put(oirq.np);
-	} else {
-		parent_irq = of_irq_get(node, 0);
 	}
 
-	if (parent_irq < 0)
-		return parent_irq;
-	else if (!parent_irq)
-		return -ENODEV;
-
-	domain = irq_domain_add_linear(node, RTL_ICTL_NUM_INPUTS, &irq_domain_ops, NULL);
-	if (!domain)
-		return -ENOMEM;
-
-	irq_set_chained_handler_and_data(parent_irq, realtek_irq_dispatch, domain);
+	/* Ensure we haven't collected any errors before proceeding */
+	for (p = 0; p < num_parents; p++) {
+		if (parent_irqs[p] < 0)
+			return parent_irqs[p];
+		if (!parent_irqs[p])
+			return -ENODEV;
+	}
 
-	return 0;
+	return setup_parent_interrupts(node, parent_irqs, num_parents);
 }
 
 IRQCHIP_DECLARE(realtek_rtl_intc, "realtek,rtl-intc", realtek_rtl_of_init);
-- 
2.35.1