[PATCH v3 1/4] dt-binding: mtd: nand: Document the wp-gpios property

[Christophe Kerello]

A few drivers use this property to describe the GPIO pin used to protect
the NAND during program/erase operations.

Signed-off-by: Christophe Kerello <christophe.kerello@xxxxxxxxxxx>
Acked-by: Rob Herring <robh@xxxxxxxxxx>
---
Changes in v2:
 - add Rob Acked-by.

 Documentation/devicetree/bindings/mtd/nand-controller.yaml | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/Documentation/devicetree/bindings/mtd/nand-controller.yaml b/Documentation/devicetree/bindings/mtd/nand-controller.yaml
index bd217e6f5018..53b21aed0ac5 100644
--- a/Documentation/devicetree/bindings/mtd/nand-controller.yaml
+++ b/Documentation/devicetree/bindings/mtd/nand-controller.yaml
@@ -154,6 +154,13 @@ patternProperties:
           Ready/Busy pins. Active state refers to the NAND ready state and
           should be set to GPIOD_ACTIVE_HIGH unless the signal is inverted.
 
+      wp-gpios:
+        description:
+          Contains one GPIO descriptor for the Write Protect pin.
+          Active state refers to the NAND Write Protect state and should be
+          set to GPIOD_ACTIVE_LOW unless the signal is inverted.
+        maxItems: 1
+
       secure-regions:
         $ref: /schemas/types.yaml#/definitions/uint64-matrix
         description:
-- 
2.25.1