Re: [PATCH V7 0/6] Use CCF to describe the UART baud rate clock

[Neil Armstrong]

Hi,

Le 25/02/2022 à 08:39, Yu Tu a écrit :
> Using the common Clock code to describe the UART baud rate
> clock makes it easier for the UART driver to be compatible
> with the baud rate requirements of the UART IP on different
> meson chips. Add Meson S4 SoC compatible.
>
> The test method:
> Start the console and run the following commands in turn:
> stty -F /dev/ttyAML0 115200 and stty -F /dev/ttyAML0 921600.
>
> Since most SoCs are too old, I was able to find all the platforms myself
> such as Meson6, Meson8, Meson8b, GXL and so on. I only tested it with
> G12A and S4.
>
> Yu Tu (6):
>    tty: serial: meson: Move request the register region to probe
>    tty: serial: meson: Use devm_ioremap_resource to get register mapped
>      memory
>    tty: serial: meson: Describes the calculation of the UART baud rate
>      clock using a clock frame
>    tty: serial: meson: Make some bit of the REG5 register writable
>    tty: serial: meson: The system stuck when you run the stty command on
>      the console to change the baud rate
>    tty: serial: meson: Added S4 SOC compatibility
>
> V6 -> V7: To solve the system stuck when you run the stty command on
> the console to change the baud rate.
> V5 -> V6: Change error format as discussed in the email.
> V4 -> V5: Change error format.
> V3 -> V4: Change CCF to describe the UART baud rate clock as discussed
> in the email.
> V2 -> V3: add compatible = "amlogic,meson-gx-uart". Because it must change
> the DTS before it can be deleted
> V1 -> V2: Use CCF to describe the UART baud rate clock.Make some changes as
> discussed in the email
>
> Link:https://lore.kernel.org/linux-amlogic/20220118030911.12815-4-yu.tu@xxxxxxxxxxx/
>
>   drivers/tty/serial/meson_uart.c | 221 ++++++++++++++++++++++----------
>   1 file changed, 154 insertions(+), 67 deletions(-)
>
>
> base-commit: a603ca60cebff8589882427a67f870ed946b3fc8

Could you send the emails To Kevin, Jerome, Martin & me, and put the various lists in CC instead ? otherwise we are not notified when the patch is accepted by the tty maintainer.

Thanks,
Neil