Re: [PATCH 5/8] arm64: dts: qcom: sa8155p-adp: Enable ethernet node

[Bhupesh Sharma]

Hi Andrew,

Sorry for the late reply.

On Thu, 27 Jan 2022 at 05:37, Andrew Lunn <andrew@xxxxxxx> wrote:
>
> > +&ethernet {
> > +     status = "okay";
> > +
> > +     snps,reset-gpio = <&tlmm 79 GPIO_ACTIVE_LOW>;
> > +     snps,reset-active-low;
> > +     snps,reset-delays-us = <0 11000 70000>;
> > +
> > +     snps,ptp-ref-clk-rate = <250000000>;
> > +     snps,ptp-req-clk-rate = <96000000>;
> > +
> > +     snps,mtl-rx-config = <&mtl_rx_setup>;
> > +     snps,mtl-tx-config = <&mtl_tx_setup>;
> > +
> > +     pinctrl-names = "default";
> > +     pinctrl-0 = <&ethernet_defaults>;
> > +
> > +     phy-handle = <&rgmii_phy>;
> > +     phy-mode = "rgmii";
>
> Where are the rgmii delays being added for this board?

I am not sure if I am missing something, but I don't see any rgmii tx
or rx delay dts properties for the dwmac-qcom-ethqos driver (see [1]
and [2]).

I see that some stmmac drivers (for e.g.
drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c), do define and use
dts properties that define the delays (for e.g.
'allwinner,tx-delay-ps'), but I cannot find something equivalent for
'dwmac-qcom-ethqos.c'.

[1]. Documentation/devicetree/bindings/net/qcom,ethqos.txt
[2]. Documentation/devicetree/bindings/net/snps,dwmac.yaml

Regards,
Bhupesh