Re: [PATCH v1 5/5] pinctrl: microchip-sgpio: wait until output is actually set

[Horatiu Vultur]

The 02/25/2022 12:29, Michael Walle wrote:
> EXTERNAL EMAIL: Do not click links or open attachments unless you know the content is safe

Hi Michael,

Sorry for late reply.

> 
> Hi Horatiu,
> 
> Am 2022-02-25 10:24, schrieb Horatiu Vultur:
> > The 02/24/2022 17:10, Michael Walle wrote:
> > > Right now, when a gpio value is set, the actual hardware pin gets set
> > > asynchronously. When linux write the output register, it takes some
> > > time
> > > until it is actually propagated to the output shift registers. If that
> > > output port is connected to an I2C mux for example, the linux driver
> > > assumes the I2C bus is already switched although it is not.
> > > 
> > > Fortunately, there is a single shot mode with a feedback: you can
> > > trigger the single shot and the hardware will clear that bit once it
> > > has
> > > finished the clocking and strobed the load signal of the shift
> > > registers. This can take a considerable amount of time though.
> > > Measuremens have shown that it takes up to a whole burst cycle gap
> > > which
> > > is about 50ms on the largest setting. Therefore, we have to mark the
> > > output bank as sleepable. To avoid unnecessary waiting, just trigger
> > > the
> > > single shot if the value was actually changed.
> > 
> > I have tested this patch series on our lan9668 board and it worked
> > fine. Thanks!
> 
> Thanks for testing!
> 
> > I just have few questions:
> > 1. What about other boards/chips that have this sgpio, do they have
> > also
> >    the same issue? Because from what I recall on sparx5 they don't have
> >    this issue. I have seen it only on lan9668.
> 
> Unfortunatly, I don't have any knowledge what IP core is used in
> which SoC. I assumed the lan9668 used the same as the sparx5. If
> that is not the case, we need a new compatible. Do you know if it
> the same?

>From what I see, it is the same IP.

> 
> On the sparx5 are there any peripheral who you would actually
> notice that the timing is off?

There are some SFP connected, similar to lan966x. So I don't understand
why that issue is not seen there.

> 
> That being said, I'd assume all the serial gpio controller has
> this "flaw". Simply because a register write won't block until the
> value is shifted out to the shift register and actualy loaded by
> strobing the load signal. It just depends on your burst setting
> (even with bursts off, and clocking all the time) on how large
> the delay is. So you might or might not notice it on a board.
> 
> Could you also have a look at the other supported sgpio block,
> the ocelot and the luton? I don't have any register description
> of these.
> 
> > 2. I remember that I have tried to fix this issue like this [1], but
> >    unfortunetly that was never accepted. Is this something that is
> > worth
> >    at looking at?
> 
> That fix is at the wrong place. You'd need to fix every gpio user, no?
> Instead this tries to fix the controller.

Yes, you are right.

> 
> > 
> > [1]
> > https://patchwork.ozlabs.org/project/linux-i2c/patch/20211103091839.1665672-3-horatiu.vultur@xxxxxxxxxxxxx/
> 
> -michael

-- 
/Horatiu