Re: [PATCH 2/7] serial: 8250_dwlib: RS485 HW full duplex support

[Lukas Wunner]

On Wed, Mar 02, 2022 at 11:56:01AM +0200, Ilpo Järvinen wrote:
> @@ -110,9 +110,14 @@ static int dw8250_rs485_config(struct uart_port *p, struct serial_rs485 *rs485)
>  
>  	if (rs485->flags & SER_RS485_ENABLED) {
>  		/* Clearing unsupported flags. */
> -		rs485->flags &= SER_RS485_ENABLED;
> -
> -		tcr |= DW_UART_TCR_RS485_EN | DW_UART_TCR_XFER_MODE_DE_OR_RE;
> +		rs485->flags &= SER_RS485_ENABLED | SER_RS485_RX_DURING_TX;
> +		tcr |= DW_UART_TCR_RS485_EN;
> +
> +		if (rs485->flags & SER_RS485_RX_DURING_TX) {
> +			tcr |= DW_UART_TCR_XFER_MODE_DE_DURING_RE;
> +		} else {
> +			tcr |= DW_UART_TCR_XFER_MODE_DE_OR_RE;
> +		}

This patch deletes lines introduced by the preceding patch.
I'd just squash the two together, I don't see much value in
introducing full duplex support in a separate patch.

Thanks,

Lukas