Re: [RFC PATCH] memory: renesas-rpc-if: Correct QSPI data transfer in Manual mode

[Krzysztof Kozlowski]

On 07/03/2022 17:44, Geert Uytterhoeven wrote:
> Hi Krzysztof and Wolfram,
> 
> CC Sergey, Prabhakar, Andrew,
> 
> On Tue, Sep 28, 2021 at 12:36 PM Krzysztof Kozlowski
> <krzysztof.kozlowski@xxxxxxxxxxxxx> wrote:
>> On Wed, 22 Sep 2021 11:10:06 +0200, Wolfram Sang wrote:
>>> This patch fixes 2 problems:
>>> [1] The output warning logs and data loss when performing
>>> mount/umount then remount the device with jffs2 format.
>>> [2] The access width of SMWDR[0:1]/SMRDR[0:1] register is wrong.
>>>
>>> This is the sample warning logs when performing mount/umount then
>>> remount the device with jffs2 format:
>>> jffs2: jffs2_scan_inode_node(): CRC failed on node at 0x031c51d4:
>>> Read 0x00034e00, calculated 0xadb272a7
>>>
>>> [...]
>>
>> Applied, thanks!
>>
>> [1/1] memory: renesas-rpc-if: Correct QSPI data transfer in Manual mode
>>       commit: fff53a551db50f5edecaa0b29a64056ab8d2bbca
> 
> While trying to enable support for RPC on Salvator-X(S)[*], I
> discovered HyperFLASH detection is broken:
> 
>     rpc-if-hyperflash rpc-if-hyperflash: probing of hyperbus device failed
> 
> Reverting all commits to the RPC driver since Sergey's original
> commit 5de15b610f785f0e ("mtd: hyperbus: add Renesas RPC-IF driver")
> fixed probing:
> 
>     rpc-if-hyperflash: Found 1 x16 devices at 0x0 in 16-bit bank.
> Manufacturer ID 0x000001 Chip ID 0x007000
>     Amd/Fujitsu Extended Query Table at 0x0040
>       Amd/Fujitsu Extended Query version 1.5.
>     rpc-if-hyperflash: CFI contains unrecognised boot bank location
> (0). Assuming bottom.
>     number of CFI chips: 1
>     10 fixed-partitions partitions found on MTD device rpc-if-hyperflash
>     Creating 10 MTD partitions on "rpc-if-hyperflash":
>     0x000000000000-0x000000040000 : "bootparam"
>     [...]
> 
> However, there's still something wrong, as all HyperFLASH contents read
> back as zeros, while the FLASH contains the full boot loader stack.
> Bisecting the reverts pointed to this patch, and just reverting this
> patch (small whitespace conflict) fixes probing, too. Still, all zeros.
> 
> Summary: needs more investigation ;-)
> 
> Wolfram: which platform did you use for QSPI testing, so I don't
> break that again?
> 
> [*] Firmware compiled with RCAR_RPC_HYPERFLASH_LOCKED=0 of course.
>     Without that (e.g. old H3 R-Car ES1.0), it crashes with an
>     Asynchronous SError Interrupt during driver initialization.

Thanks for letting me know. This patch is already in mainline, so the
solution is either to revert it or fix it. I will wait for it from you
(as in plural "you" :) ).

Best regards,
Krzysztof