[PATCH net-next v2] net: lan966x: Improve the CPU TX bitrate.

[Horatiu Vultur]

When doing manual injection of the frame, it is required to check if the
TX FIFO is ready to accept the next word of the frame. For this we are
using 'readx_poll_timeout_atomic', the only problem is that before it
actually checks the status, is determining the time when to finish polling
the status. Which seems to be an expensive operation.
Therefore check the status of the TX FIFO before calling
'readx_poll_timeout_atomic'.
Doing this will improve the TX bitrate by ~70%. Because 99% the FIFO is
ready by that time. The measurements were done using iperf3.

Before:
[ ID] Interval           Transfer     Bitrate         Retr
[  5]   0.00-10.03  sec  55.2 MBytes  46.2 Mbits/sec    0 sender
[  5]   0.00-10.04  sec  53.8 MBytes  45.0 Mbits/sec      receiver

After:
[ ID] Interval           Transfer     Bitrate         Retr
[  5]   0.00-10.10  sec  95.0 MBytes  78.9 Mbits/sec    0 sender
[  5]   0.00-10.11  sec  95.0 MBytes  78.8 Mbits/sec      receiver

Signed-off-by: Horatiu Vultur <horatiu.vultur@xxxxxxxxxxxxx>
---
v1->v2
- check for TX FIFO status before calling readx_poll_timeout_atomic
---
 drivers/net/ethernet/microchip/lan966x/lan966x_main.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/ethernet/microchip/lan966x/lan966x_main.c b/drivers/net/ethernet/microchip/lan966x/lan966x_main.c
index 81c01665d01e..e1bcb28039dc 100644
--- a/drivers/net/ethernet/microchip/lan966x/lan966x_main.c
+++ b/drivers/net/ethernet/microchip/lan966x/lan966x_main.c
@@ -185,6 +185,9 @@ static int lan966x_port_inj_ready(struct lan966x *lan966x, u8 grp)
 {
 	u32 val;
 
+	if (lan_rd(lan966x, QS_INJ_STATUS) & QS_INJ_STATUS_FIFO_RDY_SET(BIT(grp)))
+		return 0;
+
 	return readx_poll_timeout_atomic(lan966x_port_inj_status, lan966x, val,
 					 QS_INJ_STATUS_FIFO_RDY_GET(val) & BIT(grp),
 					 READL_SLEEP_US, READL_TIMEOUT_US);
-- 
2.33.0