Re: [PATCH v3 1/3] drm/bridge: ti-sn65dsi86: Support DisplayPort (non-eDP) mode

[Doug Anderson]

Hi,

On Thu, Mar 10, 2022 at 7:22 AM Kieran Bingham
<kieran.bingham+renesas@xxxxxxxxxxxxxxxx> wrote:
>
> From: Laurent Pinchart <laurent.pinchart+renesas@xxxxxxxxxxxxxxxx>
>
> Despite the SN65DSI86 being an eDP bridge, on some systems its output is
> routed to a DisplayPort connector. Enable DisplayPort mode when the next
> component in the display pipeline is detected as a DisplayPort
> connector, and disable eDP features in that case.
>
> Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@xxxxxxxxxxxxxxxx>
> Reworked to set bridge type based on the next bridge/connector.
> Signed-off-by: Kieran Bingham <kieran.bingham+renesas@xxxxxxxxxxxxxxxx>
> --
> Changes since v1/RFC:
>  - Rebased on top of "drm/bridge: ti-sn65dsi86: switch to
>    devm_drm_of_get_bridge"
>  - eDP/DP mode determined from the next bridge connector type.
>
> Changes since v2:
>  - Remove setting of Standard DP Scrambler Seed. (It's read-only).
>  - Prevent setting DP_EDP_CONFIGURATION_SET in
>    ti_sn_bridge_atomic_enable()
>  - Use Doug's suggested text for disabling ASSR on DP mode.
>
>  drivers/gpu/drm/bridge/ti-sn65dsi86.c | 23 ++++++++++++++++++++---
>  1 file changed, 20 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/gpu/drm/bridge/ti-sn65dsi86.c b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
> index c892ecba91c7..93b54fcba8ba 100644
> --- a/drivers/gpu/drm/bridge/ti-sn65dsi86.c
> +++ b/drivers/gpu/drm/bridge/ti-sn65dsi86.c
> @@ -62,6 +62,7 @@
>  #define SN_LN_ASSIGN_REG                       0x59
>  #define  LN_ASSIGN_WIDTH                       2
>  #define SN_ENH_FRAME_REG                       0x5A
> +#define  ASSR_CONTROL                          BIT(0)

nit that the ASSR_CONTROL define is no longer used.

Other than that, this patch looks fine to me.

Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>