Re: [PATCH net-next 2/3] dt-bindings: net: micrel: Configure latency values and timestamping check for LAN8814 phy

[Andrew Lunn]

On Sat, Mar 12, 2022 at 06:46:46PM -0800, Richard Cochran wrote:
> On Sat, Mar 12, 2022 at 09:04:31PM +0100, Andrew Lunn wrote:
> > Do these get passed to the kernel so the hardware can act on them, or
> > are they used purely in userspace by ptp4l?
> 
> user space only.
>  
> > If they has passed to the kernel, could we provide a getter as well as
> > a setter, so the defaults hard coded in the driver can be read back?
> 
> Any hard coded defaults in the kernel are a nuisance.
> 
> I mean, do you want user space to say,
> 
>    "okay, so I know the correct value is X.  But the drivers may offer
>    random values according to kernel version.  So, I'll read out the
>    driver value Y, and then apply X-Y."
> 
> Insanity.

No, i would not suggests that at all.

You quoted the man page and it says the default it zero. If there was
an API to ask the driver what correction it is doing, and an API to
offload the delay correction to the hardware, i would simply remove
the comment about the default being zero. If these calls return
-EOPNOTSUPP, then user space stays the same, and does actually use a
default of 0. If offload is supported, you can show the user the
current absolute values, and allow the user to set the absolute
values.

Anyway, it is clear you don't want the driver doing any correction, so
lets stop this discussion.

     Andrew