Re: [PATCH 1/3] dt-bindings: mmc: mmci: add a property to disable DMA LLI

[Yann Gautier]

On 3/14/22 23:43, Linus Walleij wrote:
> "On Fri, Mar 4, 2022 at 2:52 PM Yann Gautier <yann.gautier@xxxxxxxxxxx> wrote:
>
> > On STMicroelectronics variant of PL18x, the DMA Linked Lists are supported
> > starting from revision v2 of the peripheral. But it has limitations,
> > as all the buffers should be aligned on block size (except the last one).
> > But this cannot be guaranteed with SDIO. We should then have a property
> > to disable the support of LLI.
> >
> > Signed-off-by: Yann Gautier <yann.gautier@xxxxxxxxxxx>
>
> Actually I think this is present also on the ux500 variants. See:
> commit 2253ed4b36dc876d1598c4dab5587e537ec68c34
> "mmc: mmci: Support any block sizes for ux500v2 and qcom variant"
>
> Spot the variant data "dma_power_of_2".
>
> So whatever property you add
> to the variant data (not in the device tree please) should
> be added to the ux500 variants as well, it will *VERY* likely
> have a problem with LLI elements not being a power of 2
> as it is the ancestor of later STMicro variants.
>
> It might actually be the reason for some annoying WiFi error
> messages I have seen :/
>
> Yours,
> Linus Walleij

Hi Linus,

The STM32 variant uses an internal DMA, and the DMA functions are in its 
dedicated file. So I was planning to do the same as what is done in 
meson-gx-mmc.c: using a bounce buffer to copy from/to in case DMA 
constraints are not fulfilled. Not sure it can help for Ux500.

Ulf, before I send my new series (although it is not ready yet), would 
you be OK with the bounce buffer idea?


Best regards,
Yann