[PATCH 0/4 RESEND] Fix coherence for VMbus and PCI pass-thru devices in Hyper-V VM

[Michael Kelley]

[Resend to fix an email address typo for Bjorn Helgaas]

Hyper-V VMs have VMbus synthetic devices and PCI pass-thru devices that are added
dynamically via the VMbus protocol and are not represented in the ACPI DSDT. Only
the top level VMbus node exists in the DSDT. As such, on ARM64 these devices don't
pick up coherence information and default to not hardware coherent.  This results
in extra software coherence management overhead since the synthetic devices are
always hardware coherent. PCI pass-thru devices are also hardware coherent in all
current usage scenarios.

Fix this by propagating coherence information from the top level VMbus node in
the DSDT to all VMbus synthetic devices and PCI pass-thru devices. While smaller
granularity of control would be better, basing on the VMbus node in the DSDT
gives as escape path if a future scenario arises with devices that are not
hardware coherent.

The first two patches are prep to allow manipulating device coherence from a
module (since the VMbus driver can be built as a module) and from architecture
independent code without having a bunch of #ifdef's.

The third patch propagates the VMbus node coherence to VMbus synthetic devices.

The fourth patch propagates the coherence to PCI pass-thru devices.

Michael Kelley (4):
  ACPI: scan: Export acpi_get_dma_attr()
  dma-mapping: Add wrapper function to set dma_coherent
  Drivers: hv: vmbus: Propagate VMbus coherence to each VMbus device
  PCI: hv: Propagate coherence from VMbus device to PCI device

 drivers/acpi/scan.c                 |  1 +
 drivers/hv/vmbus_drv.c              | 15 +++++++++++++++
 drivers/pci/controller/pci-hyperv.c | 17 +++++++++++++----
 include/linux/dma-map-ops.h         |  9 +++++++++
 4 files changed, 38 insertions(+), 4 deletions(-)

-- 
1.8.3.1