Re: [PATCH v3 1/2] mtd: rawnand: meson: discard the common MMC sub clock framework

[Neil Armstrong]

Hi,

On 18/03/2022 13:41, Liang Yang wrote:
> EMMC and NAND have the same clock control register named 'SD_EMMC_CLOCK' which is
> defined in EMMC port internally. bit0~5 of 'SD_EMMC_CLOCK' is the divider and
> bit6~7 is the mux for fix pll and xtal.A common MMC and NAND sub-clock has been
> implemented and can be used by the eMMC and NAND controller (which are mutually
> exclusive anyway). Let's use this new clock.
>
> Signed-off-by: Liang Yang <liang.yang@xxxxxxxxxxx>
> ---
>   drivers/mtd/nand/raw/meson_nand.c | 101 ++++++++++++++++--------------
>   1 file changed, 53 insertions(+), 48 deletions(-)
>
> diff --git a/drivers/mtd/nand/raw/meson_nand.c b/drivers/mtd/nand/raw/meson_nand.c
> index ac3be92872d0..257ffc8a41ab 100644
> --- a/drivers/mtd/nand/raw/meson_nand.c
> +++ b/drivers/mtd/nand/raw/meson_nand.c
> @@ -10,6 +10,7 @@
>   #include <linux/dma-mapping.h>
>   #include <linux/interrupt.h>
>   #include <linux/clk.h>
> +#include <linux/clk-provider.h>
>   #include <linux/mtd/rawnand.h>
>   #include <linux/mtd/mtd.h>
>   #include <linux/mfd/syscon.h>
> @@ -19,6 +20,7 @@
>   #include <linux/iopoll.h>
>   #include <linux/of.h>
>   #include <linux/of_device.h>
> +#include <linux/of_address.h>
>   #include <linux/sched/task_stack.h>
>   
>   #define NFC_REG_CMD		0x00
> @@ -104,6 +106,9 @@
>   
>   #define PER_INFO_BYTE		8
>   
> +#define CLK_DIV_SHIFT		0
> +#define CLK_DIV_WIDTH		6
> +
>   struct meson_nfc_nand_chip {
>   	struct list_head node;
>   	struct nand_chip nand;
> @@ -151,15 +156,15 @@ struct meson_nfc {
>   	struct nand_controller controller;
>   	struct clk *core_clk;
>   	struct clk *device_clk;
> -	struct clk *phase_tx;
> -	struct clk *phase_rx;
> +	struct clk *nand_clk;
> +	struct clk_divider nand_divider;
>   
>   	unsigned long clk_rate;
>   	u32 bus_timing;
>   
>   	struct device *dev;
>   	void __iomem *reg_base;
> -	struct regmap *reg_clk;
> +	void __iomem *sd_emmc_clock;
>   	struct completion completion;
>   	struct list_head chips;
>   	const struct meson_nfc_data *data;
> @@ -235,7 +240,7 @@ static void meson_nfc_select_chip(struct nand_chip *nand, int chip)
>   	nfc->timing.tbers_max = meson_chip->tbers_max;
>   
>   	if (nfc->clk_rate != meson_chip->clk_rate) {
> -		ret = clk_set_rate(nfc->device_clk, meson_chip->clk_rate);
> +		ret = clk_set_rate(nfc->nand_clk, meson_chip->clk_rate);
>   		if (ret) {
>   			dev_err(nfc->dev, "failed to set clock rate\n");
>   			return;
> @@ -406,7 +411,6 @@ static int meson_nfc_queue_rb(struct meson_nfc *nfc, int timeout_ms)
>   	cmd = NFC_CMD_RB | NFC_CMD_RB_INT
>   		| nfc->param.chip_select | nfc->timing.tbers_max;
>   	writel(cmd, nfc->reg_base + NFC_REG_CMD);
> -
>   	ret = wait_for_completion_timeout(&nfc->completion,
>   					  msecs_to_jiffies(timeout_ms));
>   	if (ret == 0)
> @@ -985,9 +989,11 @@ static const struct mtd_ooblayout_ops meson_ooblayout_ops = {
>   	.free = meson_ooblayout_free,
>   };
>   
> +struct clk_parent_data nfc_divider_parent_data[1];
>   static int meson_nfc_clk_init(struct meson_nfc *nfc)
>   {
>   	int ret;
> +	struct clk_init_data init = {0};
>   
>   	/* request core clock */
>   	nfc->core_clk = devm_clk_get(nfc->dev, "core");
> @@ -1002,21 +1008,26 @@ static int meson_nfc_clk_init(struct meson_nfc *nfc)
>   		return PTR_ERR(nfc->device_clk);
>   	}
>   
> -	nfc->phase_tx = devm_clk_get(nfc->dev, "tx");
> -	if (IS_ERR(nfc->phase_tx)) {
> -		dev_err(nfc->dev, "failed to get TX clk\n");
> -		return PTR_ERR(nfc->phase_tx);
> -	}
> -
> -	nfc->phase_rx = devm_clk_get(nfc->dev, "rx");
> -	if (IS_ERR(nfc->phase_rx)) {
> -		dev_err(nfc->dev, "failed to get RX clk\n");
> -		return PTR_ERR(nfc->phase_rx);
> -	}
> +	init.name = devm_kstrdup(nfc->dev, "nfc#div", GFP_KERNEL);
> +	init.ops = &clk_divider_ops;
> +	nfc_divider_parent_data[0].fw_name = "device";
> +	init.parent_data = nfc_divider_parent_data;
> +	init.num_parents = 1;
> +	nfc->nand_divider.reg = nfc->sd_emmc_clock;
> +	nfc->nand_divider.shift = CLK_DIV_SHIFT;
> +	nfc->nand_divider.width = CLK_DIV_WIDTH;
> +	nfc->nand_divider.hw.init = &init;
> +	nfc->nand_divider.flags = CLK_DIVIDER_ONE_BASED |
> +				  CLK_DIVIDER_ROUND_CLOSEST |
> +				  CLK_DIVIDER_ALLOW_ZERO;
> +
> +	nfc->nand_clk = devm_clk_register(nfc->dev, &nfc->nand_divider.hw);
> +	if (IS_ERR(nfc->nand_clk))
> +		return PTR_ERR(nfc->nand_clk);
>   
>   	/* init SD_EMMC_CLOCK to sane defaults w/min clock rate */
> -	regmap_update_bits(nfc->reg_clk,
> -			   0, CLK_SELECT_NAND, CLK_SELECT_NAND);
> +	writel(CLK_SELECT_NAND | readl(nfc->sd_emmc_clock),
> +	       nfc->sd_emmc_clock);
>   
>   	ret = clk_prepare_enable(nfc->core_clk);
>   	if (ret) {
> @@ -1030,29 +1041,21 @@ static int meson_nfc_clk_init(struct meson_nfc *nfc)
>   		goto err_device_clk;
>   	}
>   
> -	ret = clk_prepare_enable(nfc->phase_tx);
> -	if (ret) {
> -		dev_err(nfc->dev, "failed to enable TX clock\n");
> -		goto err_phase_tx;
> -	}
> -
> -	ret = clk_prepare_enable(nfc->phase_rx);
> +	ret = clk_prepare_enable(nfc->nand_clk);
>   	if (ret) {
> -		dev_err(nfc->dev, "failed to enable RX clock\n");
> -		goto err_phase_rx;
> +		dev_err(nfc->dev, "pre enable NFC divider fail\n");
> +		goto err_nand_clk;
>   	}
>   
> -	ret = clk_set_rate(nfc->device_clk, 24000000);
> +	ret = clk_set_rate(nfc->nand_clk, 24000000);
>   	if (ret)
> -		goto err_disable_rx;
> +		goto err_disable_clk;
>   
>   	return 0;
>   
> -err_disable_rx:
> -	clk_disable_unprepare(nfc->phase_rx);
> -err_phase_rx:
> -	clk_disable_unprepare(nfc->phase_tx);
> -err_phase_tx:
> +err_disable_clk:
> +	clk_disable_unprepare(nfc->nand_clk);
> +err_nand_clk:
>   	clk_disable_unprepare(nfc->device_clk);
>   err_device_clk:
>   	clk_disable_unprepare(nfc->core_clk);
> @@ -1061,8 +1064,7 @@ static int meson_nfc_clk_init(struct meson_nfc *nfc)
>   
>   static void meson_nfc_disable_clk(struct meson_nfc *nfc)
>   {
> -	clk_disable_unprepare(nfc->phase_rx);
> -	clk_disable_unprepare(nfc->phase_tx);
> +	clk_disable_unprepare(nfc->nand_clk);
>   	clk_disable_unprepare(nfc->device_clk);
>   	clk_disable_unprepare(nfc->core_clk);
>   }
> @@ -1373,9 +1375,10 @@ MODULE_DEVICE_TABLE(of, meson_nfc_id_table);
>   static int meson_nfc_probe(struct platform_device *pdev)
>   {
>   	struct device *dev = &pdev->dev;
> +	struct device_node *node = dev->of_node;
>   	struct meson_nfc *nfc;
> -	struct resource *res;
> -	int ret, irq;
> +	struct resource res;
> +	int ret, irq, i;
>   
>   	nfc = devm_kzalloc(dev, sizeof(*nfc), GFP_KERNEL);
>   	if (!nfc)
> @@ -1388,21 +1391,23 @@ static int meson_nfc_probe(struct platform_device *pdev)
>   	nand_controller_init(&nfc->controller);
>   	INIT_LIST_HEAD(&nfc->chips);
>   	init_completion(&nfc->completion);
> -
>   	nfc->dev = dev;
>   
> -	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> -	nfc->reg_base = devm_ioremap_resource(dev, res);
> +	i = of_property_match_string(node, "reg-names", "nfc");
> +	if (of_address_to_resource(node, i, &res))
> +		return -ENOENT;
> +
> +	nfc->reg_base = devm_ioremap_resource(dev, &res);
>   	if (IS_ERR(nfc->reg_base))
>   		return PTR_ERR(nfc->reg_base);

You can use devm_platform_ioremap_resource_byname() here which is musch simpler,
and permits dropping platform_get_resource() at the same time.

>   
> -	nfc->reg_clk =
> -		syscon_regmap_lookup_by_phandle(dev->of_node,
> -						"amlogic,mmc-syscon");
> -	if (IS_ERR(nfc->reg_clk)) {
> -		dev_err(dev, "Failed to lookup clock base\n");
> -		return PTR_ERR(nfc->reg_clk);
> -	}
> +	i = of_property_match_string(node, "reg-names", "emmc");
> +	if (of_address_to_resource(node, i, &res))
> +		return -ENOENT;
> +
> +	nfc->sd_emmc_clock = devm_ioremap_resource(dev, &res);
> +	if (IS_ERR(nfc->sd_emmc_clock))
> +		return PTR_ERR(nfc->sd_emmc_clock);

Same here.

>   
>   	irq = platform_get_irq(pdev, 0);
>   	if (irq < 0)

Thanks !
Neil