[V3 0/3] arch: arm64: dts: qcom: Configure cts sleep pinctrl to bias-bus-hold

[Vijaya Krishna Nivarthi]

WLAN rail was leaking power during RBSC/sleep even after turning BT off.
Change sleep pinctrl configuration to handle same.

---
v3: apply same change to active state and other sc7280*.dts* as well
v2: used bias-bus-hold as per review comments
v1: intial patch used bias-disable for sleep pinctrl in sc7280-idp only
---

Vijaya Krishna Nivarthi (3):
  arch: arm64: dts: qcom: Configure cts sleep pinctrl to bias-bus-hold
  arch: arm64: dts: qcom: Configure cts sleep pinctrl to bias-bus-hold
  arch: arm64: dts: qcom: Configure cts sleep pinctrl to bias-bus-hold

 arch/arm64/boot/dts/qcom/sc7280-herobrine-herobrine-r0.dts | 12 ++++++------
 arch/arm64/boot/dts/qcom/sc7280-idp.dtsi                   | 12 ++++++------
 arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi                 | 13 ++++++++-----
 3 files changed, 20 insertions(+), 17 deletions(-)

-- 
Qualcomm INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by the Linux Foundation.