Re: [PATCH 2/3] arm64: dts: qcom: sm8350: Add GENI I2C/SPI DMA channels

[Vinod Koul]

On 12-04-22, 14:51, Bjorn Andersson wrote:
> The GENI I2C and SPI controllers may use the GPI DMA engine, define the
> rx and tx channels for these controllers to enable this.
> 
> Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/sm8350.dtsi | 108 +++++++++++++++++++++++++++
>  1 file changed, 108 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sm8350.dtsi b/arch/arm64/boot/dts/qcom/sm8350.dtsi
> index 7e585d9e4c68..8547c0b2f060 100644
> --- a/arch/arm64/boot/dts/qcom/sm8350.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sm8350.dtsi
> @@ -721,6 +721,9 @@ i2c14: i2c@880000 {
>  				pinctrl-names = "default";
>  				pinctrl-0 = <&qup_i2c14_default>;
>  				interrupts = <GIC_SPI 373 IRQ_TYPE_LEVEL_HIGH>;
> +				dmas = <&gpi_dma2 0 0 QCOM_GPI_I2C>,
> +				       <&gpi_dma2 1 0 QCOM_GPI_I2C>;
> +				dma-names = "tx", "rx";

I have been thinking about this. I dont feel this is right approach here
as this is board dependent and having the firmware loaded on the board..

This was tested on HDK and can fail in MTP or other boards.. which might
be in FIFO mode

So, I think it might be apt to move these to board dtsi.. what do you
think?

-- 
~Vinod