[PATCH v1 2/4] soc: imx: imx8m-blk-ctrl: Display Power ON sequence

[Viraj Shah]

Enable the dispmix software clock and release the resets
as shown in the 5.2.9.5 section of reference manual.

Signed-off-by: Viraj Shah <viraj.shah@xxxxxxxxxxxxx>
---
 drivers/soc/imx/imx8m-blk-ctrl.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/soc/imx/imx8m-blk-ctrl.c b/drivers/soc/imx/imx8m-blk-ctrl.c
index 122f9c884b38..ca63fd30e70a 100644
--- a/drivers/soc/imx/imx8m-blk-ctrl.c
+++ b/drivers/soc/imx/imx8m-blk-ctrl.c
@@ -99,7 +99,10 @@ static int imx8m_blk_ctrl_power_on(struct generic_pm_domain *genpd)
 		dev_err(bc->dev, "failed to enable clocks\n");
 		goto bus_put;
 	}
-	regmap_set_bits(bc->regmap, BLK_CLK_EN, data->clk_mask);
+	/* As per section 5.2.9.5 of reference manual imx-8MMini-yhsc.pdf,
+	 * enable dispmix sft clock to power on the display
+	 */
+	regmap_write(bc->regmap, BLK_CLK_EN, 0x1FFF);
 
 	/* power up upstream GPC domain */
 	ret = pm_runtime_get_sync(domain->power_dev);
@@ -112,7 +115,7 @@ static int imx8m_blk_ctrl_power_on(struct generic_pm_domain *genpd)
 	udelay(5);
 
 	/* release reset */
-	regmap_set_bits(bc->regmap, BLK_SFT_RSTN, data->rst_mask);
+	regmap_write(bc->regmap, BLK_SFT_RSTN, 0x7F);
 	if (data->mipi_phy_rst_mask)
 		regmap_set_bits(bc->regmap, BLK_MIPI_RESET_DIV, data->mipi_phy_rst_mask);
 
-- 
2.20.1