[PATCH v14 2/4] arm64: dts: qcom: sc7280: Add secondary MI2S pinmux specifications for CRD 3.0/3.1

[Srinivasa Rao Mandadapu]

Add drive strength property for secondary MI2S on
sc7280 based platforms of rev5+ (aka CRD 3.0/3.1) boards.

Signed-off-by: Srinivasa Rao Mandadapu <quic_srivasam@xxxxxxxxxxx>
Co-developed-by: Venkata Prasad Potturu <quic_potturu@xxxxxxxxxxx>
Signed-off-by: Venkata Prasad Potturu <quic_potturu@xxxxxxxxxxx>
Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/sc7280-herobrine-crd.dts | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sc7280-herobrine-crd.dts b/arch/arm64/boot/dts/qcom/sc7280-herobrine-crd.dts
index b06f61e..deaea3a 100644
--- a/arch/arm64/boot/dts/qcom/sc7280-herobrine-crd.dts
+++ b/arch/arm64/boot/dts/qcom/sc7280-herobrine-crd.dts
@@ -111,6 +111,20 @@ ap_ts_pen_1v8: &i2c13 {
  * - If a pin is not hooked up on Qcard, it gets no name.
  */
 
+&mi2s1_data0 {
+	drive-strength = <6>;
+	bias-disable;
+};
+
+&mi2s1_sclk {
+	drive-strength = <6>;
+	bias-disable;
+};
+
+&mi2s1_ws {
+	drive-strength = <6>;
+};
+
 &pm8350c_gpios {
 	gpio-line-names = "FLASH_STROBE_1",		/* 1 */
 			  "AP_SUSPEND",
-- 
2.7.4