Re: [PATCH RESEND 0/2] j1939: make sure that sent DAT/CTL frames are marked as TX

[Oleksij Rempel]

Hi Devid,

On Mon, May 09, 2022 at 07:07:44PM +0200, Devid Antonio Filoni wrote:
> Hello,
> 
> If candump -x is used to dump CAN bus traffic on an interface while a J1939
> socket is sending multi-packet messages, then the DAT and CTL frames
> show up as RX instead of TX.
> 
> This patch series sets to generated struct sk_buff the owning struct sock
> pointer so that the MSG_DONTROUTE flag can be set by recv functions.
> 
> I'm not sure that j1939_session_skb_get is needed, I think that session->sk
> could be directly passed as can_skb_set_owner parameter. This patch
> is based on j1939_simple_txnext function which uses j1939_session_skb_get.
> I can provide an additional patch to remove the calls to
> j1939_session_skb_get function if you think they are not needed.

Thank you for your patches. By testing it I noticed that there is a memory
leak in current kernel and it seems to be even worse after this patches.
Found by this test:
https://github.com/linux-can/can-tests/blob/master/j1939/run_all.sh#L13

Can you please investigate it (or wait until I get time to do it).

Regards,
Oleksij
-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |