Re: [PATCH 5/7] arm64: dts: qcom: Add PM6125 PMIC

[Marijn Suijten]

On 2022-05-13 10:24:04, Krzysztof Kozlowski wrote:
> On 12/05/2022 00:06, Marijn Suijten wrote:
> > This PMIC is commonly used on boards with an SM6125 SoC and looks very
> > similar in layout to the PM6150.
> > 
> > Downstream declares more nodes to be available, but these have been
> > omitted from this patch: the pwm/lpg block is unused on my reference
> > device making it impossible to test/validate, and the spmi-clkdiv does
> > not have a single device-tree binding using this driver yet, hence
> > inclusion is better postponed until ie. audio which uses these clocks is
> > brought up.
> > 
> > Signed-off-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
> > Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxxx>
> > Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxx>
> 
> Two reviews on first patch... :)

Same story here, we review each-others patches in advance and it'd be
annoying to have them re-send their approval through the mailing list;
only for me/us to pick it up in a v2.

> > +
> > +	pmic@1 {
> > +		compatible = "qcom,pm6125", "qcom,spmi-pmic";
> > +		reg = <0x1 SPMI_USID>;
> > +		#address-cells = <1>;
> > +		#size-cells = <0>;
> 
> No children, so this should not be needed, I think.

The size-cells or the entire node?  There's a PWM/LPG block here
according to downstream DT, but my device doesn't use it so I can't test
that it is valid.  I can add it anyway, presuming reviewers here have
the ability to validate it for me with a reference manual.

- Marijn