On 18/05/2022 19:17, Scott Branden wrote:The adapter may be used in any PCIe design that supports DMA.
Hi Guilherme,
+Desmond
[...]
We register to the panic notifier so that we can kill the VK card ASAP[...]I'm afraid it breaks kdump if this device is not reset beforehand - it's
a doorbell write, so not high risk I think...
But in case the not-reset device can be probed normally in kdump kernel,
then I'm fine in moving this to the reboot list! I don't have the HW to
test myself.
Good question. Well, it if has to be called before kdump then
even "hypervisor" list is a wrong place because is not always
called before kdump.
to stop DMAing things over to the host side. If it is not notified then
memory may not be frozen when kdump is occurring.
Notifying the card on panic is also needed to allow for any type of
reset to occur.
So, the only thing preventing moving the notifier later is the chance
that memory is modified while kdump is occurring. Or, if DMA is
disabled before kdump already then this wouldn't be an issue and the
notification to the card (to allow for clean resets) can be done later.
Hi Scott / Desmond, thanks for the detailed answer! Is this adapter
designed to run in x86 only or you have other architectures' use cases?
Sounds the best to keep system operating as tested today.
I'm not expert on that, but I guess whether DMA is "kept" or not depends
a bit if IOMMU is used. IIRC, there was a copy of the DMAR table in
kdump (at least for Intel IOMMU). Also, devices are not properly
quiesced on kdump IIUC, we don't call shutdown/reset handlers, they're
skip due to the crash nature - so there is a risk of devices doing bad
things in the new kernel.
With that said, and given this is a lightweight notifier that ideally
should run ASAP, I'd keep this one in the hypervisor list. We can
"adjust" the semantic of this list to include lightweight notifiers that
reset adapters.
It may be beneficial for some other drivers but for our use we would then need to register for the panic path and the crash_shutdown path. We notify the VK card for 2 purposes: one to stop DMA so memory stop changing during a kdump. And also to get the card into a good state so resets happen cleanly.
With that said, Petr has a point - not always such list is going to be
called before kdump. So, that makes me think in another idea: what if we
have another list, but not on panic path, but instead in the custom
crash_shutdown()? Drivers could add callbacks there that must execute
before kexec/kdump, no matter what.
Let me know your thoughts Scott / Desmond / Petr and all interested parties.
Cheers,
Guilherme
Attachment:
smime.p7s
Description: S/MIME Cryptographic Signature