Re: [PATCHv2 1/2] i2c: designware: introduce a custom scl recovery for SoCFPGA platforms

[Dinh Nguyen]

On 5/24/22 11:43, Andy Shevchenko wrote:
> On Tue, May 24, 2022 at 08:54:40AM -0500, Dinh Nguyen wrote:
> > The I2C pins on the SoCFPGA platforms do not go through a GPIO module,
> > thus cannot be recovered by the default method of by doing a GPIO access.
> > Only a reset of the I2C IP block can a recovery be successful.
>
> Better now, but see my additional comments.
>
> ...
>
> > +	switch (dev->flags & MODEL_MASK) {
> > +	case MODEL_SOCFPGA:
> > +		rinfo->recover_bus = i2c_socfpga_scl_recovery;
> > +		break;
> > +	default:
> > +		rinfo->recover_bus = i2c_generic_scl_recovery;
> > +		break;
> > +	}
>
> > +	adap->bus_recovery_info = rinfo;
>
> Usually we do not assign the pointer while data structure is incomplete.
> That's said, please leave this line as it was.
>
> On top of that, why you can't move the above switch to the place where old
> function was assigned?

The reason is the assignment of the recover_bus needs to get done before 
the call to devm_gpiod_get_optional(), otherwise, the assignment is not 
taking place because of an error after returning from 
devm_gpiod_get_optional().

Dinh