[PATCH v1] PCI: qcom: Allow L1 and its sub states on qcom dwc wrapper

[Krishna chaitanya chundru]

Allow L1 and its sub-states in the qcom dwc pcie wrapper.
By default its disabled. So enable it explicitly.

Signed-off-by: Krishna chaitanya chundru <quic_krichai@xxxxxxxxxxx>
---
 drivers/pci/controller/dwc/pcie-qcom.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 6ab9089..f60645c 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -41,6 +41,9 @@
 #define L23_CLK_RMV_DIS				BIT(2)
 #define L1_CLK_RMV_DIS				BIT(1)
 
+#define PCIE20_PARF_PM_CTRL			0x20
+#define REQ_NOT_ENTR_L1				BIT(5)
+
 #define PCIE20_PARF_PHY_CTRL			0x40
 #define PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK	GENMASK(20, 16)
 #define PHY_CTRL_PHY_TX0_TERM_OFFSET(x)		((x) << 16)
@@ -1267,6 +1270,11 @@ static int qcom_pcie_init_2_7_0(struct qcom_pcie *pcie)
 	val |= BIT(4);
 	writel(val, pcie->parf + PCIE20_PARF_MHI_CLOCK_RESET_CTRL);
 
+	/* Clear PARF PM REQ_NOT_ENTR_L1 bit to allow L1 states */
+	val = readl(pcie->parf + PCIE20_PARF_PM_CTRL);
+	val &= ~REQ_NOT_ENTR_L1;
+	writel(val, pcie->parf + PCIE20_PARF_PM_CTRL);
+
 	if (IS_ENABLED(CONFIG_PCI_MSI)) {
 		val = readl(pcie->parf + PCIE20_PARF_AXI_MSTR_WR_ADDR_HALT);
 		val |= BIT(31);
-- 
2.7.4