Re: [aarch64] INFO: rcu_sched detected expedited stalls on CPUs/tasks

[Bruno Goncalves]

On Fri, 3 Jun 2022 at 17:24, Pierre Gondois <pierre.gondois@xxxxxxx> wrote:
>
> Hello Bruno,
> This looks like something we noticed on the PCC channel of the Tx2. Here was
> the original message:
> '''
> It seems there is synchronization issue on the PCC channels of the ThunderX2.
>
> Some abbreviations first. References are always to ACPI 6.4:
> Command Complete bit (CCb):
> 1 means the OS owns the PCC channel, 0 means the firmware owns the channel,
> cf s14.2.2 "Generic Communications Channel Status Field"
>
> Doorbell Write bits (DWb):
> Write a mask (just one bit in our case) to the doorbell register to notify the
> firmware of a message waiting in the channel,
> cf s14.1.4 "HW-Reduced Communications Subspace Structure (type 1)"
>
> Minimum Request Turnaround Time (MRTT):
> PCC channels have a 'Minimum Request Turnaround Time', being 'The minimum
> amount of time that OSPM must wait after the completion of a command before
> issuing the next command'.
> cf s14.1.4 "HW-Reduced Communications Subspace Structure (type 1)"
>
> The scenario that seems to cause trouble is:
> 1. The OS places a payload and clears the CCb bit
> 2. The OS rings at the doorbell (sets the DWb)
> 3. The firmware processes the message and then sets the CCb (the DWb seems to
>     be still set)
> 4. The OS continues (the DWb seems to be still set)
> 5. The OS wants to send another command. The MRTT has elapsed. So the OS does
>      1. again. (the DWb seems to be still set)
> 6. The OS does 2. again, but the DWb are still set so the OS overwrites the DWb
> 7. The firmware finally clears the DWb.
>
>   From 7.:
> - The OS indefinitely waits for an answer, thinking the firmware needs
>    to answer. The timeout of this request elapses, but the channel is still
>    assumed to belong to the firmware, so the OS never rings the doorbell again.
> - The firmware waits for the doorbell to ring (the DWb to be set), but the
>    OS never rings again.
>
> This can be reproduced by running a big load (e.g. 60 tasks running at 5%
> of the maximum CPU capacity). PCCT tables must have been published by
> selecting the right option in UEFI.
>
> Doubling the MRTT (going from 5ms to 10ms) makes the synchronization issue
> disappears, but it means decreasing the speed of all PCC channels.
> '''
>
> If you get messages such as:
> "PCC check channel failed for ss: XX. ret=X"
> then this should be the same issue.

Thanks for your reply, on console.log we don't see the message above.

Bruno

>
> What might be happening for you is that a stall is detected while the
> sugov_work thread is trying to set a frequency. check_pcc_chan() waits for
> 500 * 3000 us (the PCC channel nominal latency for the Tx2) = 1.5s, which
> is quite long.
>
> Cf. the end of the original message, could you try increasing the mrtt value ?
> (here it is doubled)
> pcc_data[pcc_ss_idx]->pcc_mrtt = 2 * pcc_chan->min_turnaround_time;
> https://github.com/torvalds/linux/blob/50fd82b3a9a9335df5d50c7ddcb81c81d358c4fc/drivers/acpi/cppc_acpi.c#L547
> (for info, where the cppc dirvers waits for the mrtt to elapse)
> https://github.com/torvalds/linux/blob/50fd82b3a9a9335df5d50c7ddcb81c81d358c4fc/drivers/acpi/cppc_acpi.c#L263
>
> On 6/3/22 11:44, Bruno Goncalves wrote:
> > Hello,
> >
> > We recently started to hit this problem on some of our aarch64
> > machines. The stalls can happen even during boot.
> >
> > [ 1086.949484] rcu: INFO: rcu_sched detected expedited stalls on
> > CPUs/tasks: { 23-... } 3 jiffies s: 3441 root: 0x2/.
> > [ 1086.949510] rcu: blocking rcu_node structures (internal RCU debug):
> > l=1:16-31:0x80/.
> > [ 1086.949524] Task dump for CPU 23:
> > [ 1086.949528] task:sugov:23        state:R  running task     stack:
> >   0 pid: 2914 ppid:     2 flags:0x0000000a
> > [ 1086.949543] Call trace:
> > [ 1086.949546]  __switch_to+0x104/0x19c
> > [ 1086.949568]  __schedule+0x410/0x67c
> > [ 1086.949576]  schedule+0x70/0xa8
> > [ 1086.949583]  schedule_hrtimeout_range_clock+0x144/0x1d8
> > [ 1086.949592]  schedule_hrtimeout_range+0x20/0x2c
> > [ 1086.949598]  usleep_range_state+0x5c/0x80
> > [ 1086.949603]  check_pcc_chan+0x7c/0xf4
> > [ 1086.949615]  send_pcc_cmd+0x130/0x2a8
> > [ 1086.949619]  cppc_set_perf+0x12c/0x22c
> > [ 1086.949624]  cppc_cpufreq_set_target+0xf8/0x15c [cppc_cpufreq]
> > [ 1086.949645]  __cpufreq_driver_target+0x94/0xfc
> > [ 1086.949658]  sugov_work+0x98/0xe0
> > [ 1086.949675]  kthread_worker_fn+0x124/0x2b8
> > [ 1086.949683]  kthread+0xd4/0x558
> > [ 1086.949689]  ret_from_fork+0x10/0x20
> >
> > More logs:
> > https://s3.us-east-1.amazonaws.com/arr-cki-prod-datawarehouse-public/datawarehouse-public/2022/06/02/553734635/redhat:553734635_aarch64/tests/Storage_block_filesystem_fio_test/12073991_aarch64_1_dmesg.log
> >
> > https://s3.us-east-1.amazonaws.com/arr-cki-prod-datawarehouse-public/datawarehouse-public/2022/06/02/553734635/redhat:553734635_aarch64/tests/Boot_test/12073991_aarch64_1_test_console.log
> >
> > CKI issue tracker: https://datawarehouse.cki-project.org/issue/1259
> >
> > Thanks,
> > Bruno Goncalves
> >
>