[PATCH V14 4/9] mfd: pm8008: Add reset-gpios

[Satya Priya]

Add the reset-gpio toggling in the pm8008_probe() to bring
pm8008 chip out of reset instead of doing it in DT node using
"output-high" property.

Signed-off-by: Satya Priya <quic_c_skakit@xxxxxxxxxxx>
Reviewed-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
---
Changes in V14:
 - None.

Changes in V13:
 - None.

Changes in V12:
 - Move reset_gpio acquiring above probe_irq_peripherals in pm8008_probe.

Changes in V11:
 - Use local variable for reset_gpios as it is not used outside of probe.
 - Use GPIOD_OUT_LOW flag to initialize the gpio and remove below line
   as it is not required "gpiod_set_value(chip->reset_gpio, 1);".

 drivers/mfd/qcom-pm8008.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/mfd/qcom-pm8008.c b/drivers/mfd/qcom-pm8008.c
index c472d7f..5a670b0 100644
--- a/drivers/mfd/qcom-pm8008.c
+++ b/drivers/mfd/qcom-pm8008.c
@@ -4,6 +4,7 @@
  */
 
 #include <linux/bitops.h>
+#include <linux/gpio/consumer.h>
 #include <linux/i2c.h>
 #include <linux/interrupt.h>
 #include <linux/irq.h>
@@ -221,6 +222,7 @@ static int pm8008_probe(struct i2c_client *client)
 {
 	int rc;
 	struct pm8008_data *chip;
+	struct gpio_desc *reset_gpio;
 
 	chip = devm_kzalloc(&client->dev, sizeof(*chip), GFP_KERNEL);
 	if (!chip)
@@ -233,6 +235,10 @@ static int pm8008_probe(struct i2c_client *client)
 
 	i2c_set_clientdata(client, chip);
 
+	reset_gpio = devm_gpiod_get(chip->dev, "reset", GPIOD_OUT_LOW);
+	if (IS_ERR(reset_gpio))
+		return PTR_ERR(reset_gpio);
+
 	if (of_property_read_bool(chip->dev->of_node, "interrupt-controller")) {
 		rc = pm8008_probe_irq_peripherals(chip, client->irq);
 		if (rc)
-- 
2.7.4