[PATCH] drm/msm/dsi: Use single function for reset

[Luca Weiss]

From: Vladimir Lypak <vladimir.lypak@xxxxxxxxx>

There is currently two function for performing reset: dsi_sw_reset and
dsi_sw_reset_restore. Only difference betwean those is that latter one
assumes that DSI controller is enabled. In contrary former one assumes
that controller is disabled and executed during power-on. However this
assumtion is not true mobile devices which have boot splash set up by
boot-loader.

This patch removes dsi_sw_reset_restore and makes dsi_sw_reset disable
DSI controller during reset sequence if it's enabled.

Signed-off-by: Vladimir Lypak <vladimir.lypak@xxxxxxxxx>
Signed-off-by: Luca Weiss <luca@xxxxxxxxx>
---
 drivers/gpu/drm/msm/dsi/dsi_host.c | 48 +++++++++++++-----------------
 1 file changed, 21 insertions(+), 27 deletions(-)

diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
index a95d5df52653..bab2634ebd11 100644
--- a/drivers/gpu/drm/msm/dsi/dsi_host.c
+++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
@@ -1080,12 +1080,32 @@ static void dsi_timing_setup(struct msm_dsi_host *msm_host, bool is_bonded_dsi)
 
 static void dsi_sw_reset(struct msm_dsi_host *msm_host)
 {
+	u32 ctrl;
+
+	ctrl = dsi_read(msm_host, REG_DSI_CTRL);
+
+	if (ctrl & DSI_CTRL_ENABLE) {
+		dsi_write(msm_host, REG_DSI_CTRL, ctrl & ~DSI_CTRL_ENABLE);
+		/*
+		 * dsi controller need to be disabled before
+		 * clocks turned on
+		 */
+		wmb();
+	}
+
 	dsi_write(msm_host, REG_DSI_CLK_CTRL, DSI_CLK_CTRL_ENABLE_CLKS);
 	wmb(); /* clocks need to be enabled before reset */
 
+	/* dsi controller can only be reset while clocks are running */
 	dsi_write(msm_host, REG_DSI_RESET, 1);
 	msleep(DSI_RESET_TOGGLE_DELAY_MS); /* make sure reset happen */
 	dsi_write(msm_host, REG_DSI_RESET, 0);
+	wmb(); /* controller out of reset */
+
+	if (ctrl & DSI_CTRL_ENABLE) {
+		dsi_write(msm_host, REG_DSI_CTRL, ctrl);
+		wmb();	/* make sure dsi controller enabled again */
+	}
 }
 
 static void dsi_op_mode_config(struct msm_dsi_host *msm_host,
@@ -1478,32 +1498,6 @@ static int dsi_cmds2buf_tx(struct msm_dsi_host *msm_host,
 	return len;
 }
 
-static void dsi_sw_reset_restore(struct msm_dsi_host *msm_host)
-{
-	u32 data0, data1;
-
-	data0 = dsi_read(msm_host, REG_DSI_CTRL);
-	data1 = data0;
-	data1 &= ~DSI_CTRL_ENABLE;
-	dsi_write(msm_host, REG_DSI_CTRL, data1);
-	/*
-	 * dsi controller need to be disabled before
-	 * clocks turned on
-	 */
-	wmb();
-
-	dsi_write(msm_host, REG_DSI_CLK_CTRL, DSI_CLK_CTRL_ENABLE_CLKS);
-	wmb();	/* make sure clocks enabled */
-
-	/* dsi controller can only be reset while clocks are running */
-	dsi_write(msm_host, REG_DSI_RESET, 1);
-	msleep(DSI_RESET_TOGGLE_DELAY_MS); /* make sure reset happen */
-	dsi_write(msm_host, REG_DSI_RESET, 0);
-	wmb();	/* controller out of reset */
-	dsi_write(msm_host, REG_DSI_CTRL, data0);
-	wmb();	/* make sure dsi controller enabled again */
-}
-
 static void dsi_hpd_worker(struct work_struct *work)
 {
 	struct msm_dsi_host *msm_host =
@@ -1520,7 +1514,7 @@ static void dsi_err_worker(struct work_struct *work)
 
 	pr_err_ratelimited("%s: status=%x\n", __func__, status);
 	if (status & DSI_ERR_STATE_MDP_FIFO_UNDERFLOW)
-		dsi_sw_reset_restore(msm_host);
+		dsi_sw_reset(msm_host);
 
 	/* It is safe to clear here because error irq is disabled. */
 	msm_host->err_work_state = 0;
-- 
2.36.1