Re: [PATCH] spi: aspeed: Fix division by zero

From: Cédric Le Goater
Date: Mon Jun 13 2022 - 05:49:04 EST


On 6/13/22 10:39, Pratyush Yadav wrote:
On 11/06/22 12:39PM, Cédric Le Goater wrote:
When using the normal read operation for data transfers, the dummy bus
width is zero. In that case, they are no dummy bytes to transfer and
setting the dummy field in the controller register becomes useless.

Issue was found on a custom "Bifrost" board with a AST2500 SoC and
using a MX25L51245GMI-08G SPI Flash.

Cc: Chin-Ting Kuo <chin-ting_kuo@xxxxxxxxxxxxxx>
Reported-by: Ian Woloschin <ian.woloschin@xxxxxxxxxx>
Fixes: 54613fc6659b ("spi: aspeed: Add support for direct mapping")
Signed-off-by: Cédric Le Goater <clg@xxxxxxxx>
---
drivers/spi/spi-aspeed-smc.c | 12 +++++++++++-
1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-aspeed-smc.c b/drivers/spi/spi-aspeed-smc.c
index 496f3e1e9079..3e891bf22470 100644
--- a/drivers/spi/spi-aspeed-smc.c
+++ b/drivers/spi/spi-aspeed-smc.c
@@ -558,6 +558,14 @@ static int aspeed_spi_dirmap_create(struct spi_mem_dirmap_desc *desc)
u32 ctl_val;
int ret = 0;
+ dev_dbg(aspi->dev,
+ "CE%d %s dirmap [ 0x%.8llx - 0x%.8llx ] OP %#x mode:%d.%d.%d.%d naddr:%#x ndummies:%#x\n",
+ chip->cs, op->data.dir == SPI_MEM_DATA_IN ? "read" : "write",
+ desc->info.offset, desc->info.offset + desc->info.length,
+ op->cmd.opcode, op->cmd.buswidth, op->addr.buswidth,
+ op->dummy.buswidth, op->data.buswidth,
+ op->addr.nbytes, op->dummy.nbytes);
+

Unrelated change. Please send as a separate patch.

OK.
chip->clk_freq = desc->mem->spi->max_speed_hz;
/* Only for reads */
@@ -574,9 +582,11 @@ static int aspeed_spi_dirmap_create(struct spi_mem_dirmap_desc *desc)
ctl_val = readl(chip->ctl) & ~CTRL_IO_CMD_MASK;
ctl_val |= aspeed_spi_get_io_mode(op) |
op->cmd.opcode << CTRL_COMMAND_SHIFT |
- CTRL_IO_DUMMY_SET(op->dummy.nbytes / op->dummy.buswidth) |
CTRL_IO_MODE_READ;
+ if (op->dummy.nbytes)
+ ctl_val |= CTRL_IO_DUMMY_SET(op->dummy.nbytes / op->dummy.buswidth);
+

LGTM. With the above fixed,

Reviewed-by: Pratyush Yadav <p.yadav@xxxxxx>

Thanks,

C.


/* Tune 4BYTE address mode */
if (op->addr.nbytes) {
u32 addr_mode = readl(aspi->regs + CE_CTRL_REG);
--
2.35.3