[PATCH 3/4] pinctrl: pinctrl-zynqmp: Add support for output-enable and bias-high-impedance

[Sai Krishna Potthuri]

Add support to handle 'output-enable' and 'bias-high-impedance'
configurations. As part of the output-enable configuration, ZynqMP pinctrl
driver takes care of removing the pins from tri-state.

Signed-off-by: Sai Krishna Potthuri <lakshmi.sai.krishna.potthuri@xxxxxxxxxx>
---
 drivers/pinctrl/pinctrl-zynqmp.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/pinctrl/pinctrl-zynqmp.c b/drivers/pinctrl/pinctrl-zynqmp.c
index e14012209992..b25e9e76fbf8 100644
--- a/drivers/pinctrl/pinctrl-zynqmp.c
+++ b/drivers/pinctrl/pinctrl-zynqmp.c
@@ -410,6 +410,10 @@ static int zynqmp_pinconf_cfg_set(struct pinctrl_dev *pctldev,
 
 			break;
 		case PIN_CONFIG_BIAS_HIGH_IMPEDANCE:
+			param = PM_PINCTRL_CONFIG_TRI_STATE;
+			arg = PM_PINCTRL_TRI_STATE_ENABLE;
+			ret = zynqmp_pm_pinctrl_set_config(pin, param, arg);
+			break;
 		case PIN_CONFIG_MODE_LOW_POWER:
 			/*
 			 * These cases are mentioned in dts but configurable
@@ -418,6 +422,11 @@ static int zynqmp_pinconf_cfg_set(struct pinctrl_dev *pctldev,
 			 */
 			ret = 0;
 			break;
+		case PIN_CONFIG_OUTPUT_ENABLE:
+			param = PM_PINCTRL_CONFIG_TRI_STATE;
+			arg = PM_PINCTRL_TRI_STATE_DISABLE;
+			ret = zynqmp_pm_pinctrl_set_config(pin, param, arg);
+			break;
 		default:
 			dev_warn(pctldev->dev,
 				 "unsupported configuration parameter '%u'\n",
-- 
2.17.1