[PATCH v3 00/16] Add support for AXP192 PMIC
From: Aidan MacDonald
Date: Sat Jun 18 2022 - 17:40:11 EST
Changes in v3:
* Update pinctrl driver to address Andy Shevchenko's review comments
from v1, and fix a few other issues.
* Add gpio-ranges property and example snippet to gpio DT bindings.
* Update commit message of patch 01/16 to point out that all register
addresses are obtained using sub_irq_reg().
* Document ccc_table in axp20x_battery. Also update commit message to
note a small fix that is part of that patch.
* Drop axp20x_adc consolidation patch in favor of using separate adc_raw
functions. It's a minor code size optimization that may not be worth
the effort due to implementation complexity.
* Use the FIELD_GET macro in axp20x_adc to further clarify intent.
* Fix a typo in the regulator driver where an AXP20X regulator ID was
mistakenly used instead of an AXP192 regulator ID. Also carry over
an Acked-by: tag from v1. Hope that's okay.
* Accumulate Acked-by: tags from v1 on DT patches.
* Accumulate Acked-by: tags from v2.
Note that regmap maintainer Mark Brown has said the first two patches to
regmap-irq aren't suitable for inclusion into the kernel in their current
state. I'm including them for v3 so the series remains testable.
Changes in v2:
* Do a little cleanup of axp20x_adc suggested by Jonathan Cameron
* Consolidate ADC read functions in axp20x_adc
* Drop the axp192's read_label callback in axp20x_adc
* Clean up the axp192-gpio dt bindings
* Rewrite a problematic bit of code in axp20x_usb_power reported
by kernel test robot
* Support AXP192 in axp20x_battery
* Split up regmap-irq changes to two separate patches
Cover letter from v1:
Hi all,
This patch series adds support for the X-Powers AXP192 PMIC to the
AXP20x driver framework.
The first patch is a small change to regmap-irq to support the AXP192's
unusual IRQ register layout. It isn't possible to include all of the
IRQ registers in one regmap-irq chip without this.
The rest of the changes are pretty straightforward, I think the only
notable parts are the axp20x_adc driver where there seems to be some
opportunities for code reuse (the axp192 is nearly a duplicate of the
axp20x) and the addition of a new pinctrl driver for the axp192, since
the axp20x pinctrl driver was not very easy to adapt.
Aidan MacDonald (16):
regmap-irq: Use sub_irq_reg() to calculate unmask register address
regmap-irq: Add get_irq_reg to support unusual register layouts
dt-bindings: mfd: add bindings for AXP192 MFD device
dt-bindings: iio: adc: axp209: Add AXP192 compatible
dt-bindings: power: supply: axp20x: Add AXP192 compatible
dt-bindings: gpio: Add AXP192 GPIO bindings
dt-bindings: power: axp20x-battery: Add AXP192 compatible
mfd: axp20x: Add support for AXP192
regulator: axp20x: Add support for AXP192
iio: adc: axp20x_adc: Minor code cleanups
iio: adc: axp20x_adc: Add support for AXP192
power: supply: axp20x_usb_power: Add support for AXP192
pinctrl: Add AXP192 pin control driver
power: axp20x_battery: Add constant charge current table
power: axp20x_battery: Support battery status without fuel gauge
power: axp20x_battery: Add support for AXP192
.../bindings/gpio/x-powers,axp192-gpio.yaml | 68 +++
.../bindings/iio/adc/x-powers,axp209-adc.yaml | 18 +
.../bindings/mfd/x-powers,axp152.yaml | 1 +
.../x-powers,axp20x-battery-power-supply.yaml | 1 +
.../x-powers,axp20x-usb-power-supply.yaml | 1 +
drivers/base/regmap/regmap-irq.c | 19 +-
drivers/iio/adc/axp20x_adc.c | 359 +++++++++--
drivers/mfd/axp20x-i2c.c | 2 +
drivers/mfd/axp20x.c | 153 +++++
drivers/pinctrl/Kconfig | 14 +
drivers/pinctrl/Makefile | 1 +
drivers/pinctrl/pinctrl-axp192.c | 562 ++++++++++++++++++
drivers/power/supply/axp20x_battery.c | 143 ++++-
drivers/power/supply/axp20x_usb_power.c | 80 ++-
drivers/regulator/axp20x-regulator.c | 101 +++-
include/linux/mfd/axp20x.h | 84 +++
include/linux/regmap.h | 5 +
17 files changed, 1529 insertions(+), 83 deletions(-)
create mode 100644 Documentation/devicetree/bindings/gpio/x-powers,axp192-gpio.yaml
create mode 100644 drivers/pinctrl/pinctrl-axp192.c
--
2.35.1