[PATCH v2 0/2] Add Richtek RTQ6056 support

[cy_huang]

From: ChiYuan Huang <cy_huang@xxxxxxxxxxx>

This patch series is to enable Richtek RTQ6056 support.

The RTQ6056 is a high accuracy current-sense monitor with I2C interface, and
the device provides full information for system by reading out the load current
and power.

Since v2
- Change the resistor property name to be generic 'shunt-resistor-micro-ohms'.
- Rename file from 'rtq6056-adc' to 'rtq6056'.
- Refine the ABI, if generic already defined it, remove it and check the channel
  report unit.
- Add copyright text.
- include the correct header.
- change the property parsing name.
- To use iio_chan_spec address field.
- Refine each channel separate and shared_by_all.
- Use pm_runtime and pm_runtime_autosuspend.
- Remove the shutdown callback. From the HW suggestion, it's not recommended to
  use battery as the power supply.
- Check all scale unit (voltage->mV, current->mA, power->milliWatt).
- Use the read_avail to provide the interface for attribute value list.
- Add comma for the last element in the const integer array.
- Refine each ADC label text.
- In read_label callback, replace snprintf to sysfs_emit.


ChiYuan Huang (2):
  dt-bindings: iio: adc: Add rtq6056 adc support
  iio: adc: Add rtq6056 support

 .../ABI/testing/sysfs-bus-iio-adc-rtq6056          |   6 +
 .../bindings/iio/adc/richtek,rtq6056.yaml          |  56 ++
 drivers/iio/adc/Kconfig                            |  15 +
 drivers/iio/adc/Makefile                           |   1 +
 drivers/iio/adc/rtq6056.c                          | 670 +++++++++++++++++++++
 5 files changed, 748 insertions(+)
 create mode 100644 Documentation/ABI/testing/sysfs-bus-iio-adc-rtq6056
 create mode 100644 Documentation/devicetree/bindings/iio/adc/richtek,rtq6056.yaml
 create mode 100644 drivers/iio/adc/rtq6056.c

-- 
2.7.4