Re: [PATCH v1 4/6] iommu/vt-d: Add VTD_FLAG_IOMMU_PROBED flag
From: Baolu Lu
Date: Thu Jun 30 2022 - 23:17:37 EST
On 6/30/22 4:29 PM, Tian, Kevin wrote:
From: Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx>
Sent: Saturday, June 25, 2022 8:52 PM
In the IOMMU hot-add path, there's a need to check whether an IOMMU
has been probed. Instead of checking the IOMMU pointer in the global
list, it's better to allocate a flag bit in iommu->flags for this
purpose.
Sorry I didn't get the point of original check. This is the hotplug path
hence the caller of this function should already figure out it's a new
iommu before reaching this point?
Either did I. It was added by below commit without any comments about
this check.
commit ffebeb46dd34736c90ffbca1ccb0bef8f4827c44
Author: Jiang Liu <jiang.liu@xxxxxxxxxxxxxxx>
Date: Sun Nov 9 22:48:02 2014 +0800
iommu/vt-d: Enhance intel-iommu driver to support DMAR unit hotplug
Implement required callback functions for intel-iommu driver
to support DMAR unit hotplug.
Signed-off-by: Jiang Liu <jiang.liu@xxxxxxxxxxxxxxx>
Reviewed-by: Yijing Wang <wangyijing@xxxxxxxxxx>
Signed-off-by: Joerg Roedel <jroedel@xxxxxxx>
I went through the whole hot-add process and found this check seemed to
be duplicate.
Hot-add process starts from dmar_device_hotplug(), it uses a rwlock to
synchronize the hot-add paths.
2386 down_write(&dmar_global_lock);
2387 if (insert)
2388 ret = dmar_hotplug_insert(tmp);
2389 else
2390 ret = dmar_hotplug_remove(tmp);
2391 up_write(&dmar_global_lock);
dmar_device_hotplug()
->dmar_hotplug_insert()
-->dmar_parse_one_drhd() /* the added intel_iommu is allocated here*/
-->dmar_hp_add_drhd() /* the intel_iommu is about to bring up */
--->intel_iommu_add()
The duplicate check here:
if (g_iommus[iommu->seq_id])
return 0;
All the iommu units are allocated and then initialized in the same
synchronized path. There is no need to check a duplicate initialization.
I would like to remove this check if no objection.
Best regards,
baolu