Re: [PATCH 1/3] gpio: regmap: Support registers with more than one bit per GPIO

[Michael Walle]

Am 2022-07-03 13:10, schrieb Aidan MacDonald:
> Some devices use a multi-bit register field to change the GPIO
> input/output direction. Add the ->reg_field_xlate() callback to
> support such devices in gpio-regmap.
>
> ->reg_field_xlate() builds on ->reg_mask_xlate() by allowing the
> driver to return a mask and values to describe a register field.
> gpio-regmap will use the mask to isolate the field and compare or
> update it using the values to implement GPIO level and direction
> get and set ops.

Thanks for working on this. Here are my thoughts on how to improve
it:
 - I'm wary on the value translation of the set and get, you
   don't need that at the moment, correct? I'd concentrate on
   the direction for now.
 - I'd add a xlate_direction(), see below for an example
 - because we can then handle the value too, we don't need the
   invert handling in the {set,get}_direction. drop it there
   and handle it in a simple_xlat. In gpio_regmap,
   store "reg_dir_base" and "invert_direction", derived from
   config->reg_dir_in_base and config->reg_dir_out_base.

static int gpio_regmap_simple_xlat_direction(struct gpio_regmap *gpio
                                             unsigend int base,
                                             unsigned int offset,
                                             unsigned int *dir_out,
                                             unsigned int *dir_in)
{
    unsigned int line = offset % gpio->ngpio_per_reg;
    unsigned int mask = BIT(line);

    if (!gpio->invert_direction) {
        *dir_out = mask;
        *dir_in = 0;
    } else {
        *dir_out = 0;
        *dir_in = mask;
    }

    return 0;
}

And in the {set,get}_direction() you can then check both
values and convert it from or to GPIO_LINE_DIRECTION_{OUT,IN}.

Thoughts?

-michael