[PATCH v2 11/11] net: phy: aquantia: Add support for rate adaptation

[Sean Anderson]

This adds support for rate adaptation for phys similar to the AQR107. We
assume that all phys using aqr107_read_status support rate adaptation.
However, it could be possible to determine support based on the firmware
revision if there are phys discovered which do not support rate adaptation.
However, as rate adaptation is advertised in the datasheets for these phys,
I suspect it is supported most boards.

Despite the name, the "config" registers are updated with the current rate
adaptation method (if any). Because they appear to be updated
automatically, I don't know if these registers can be used to disable rate
adaptation.

Signed-off-by: Sean Anderson <sean.anderson@xxxxxxxx>
---

Changes in v2:
- Add comments clarifying the register defines
- Reorder variables in aqr107_read_rate

 drivers/net/phy/aquantia_main.c | 37 +++++++++++++++++++++++++++++----
 1 file changed, 33 insertions(+), 4 deletions(-)

diff --git a/drivers/net/phy/aquantia_main.c b/drivers/net/phy/aquantia_main.c
index 1e7036945a4e..dd73891cf68a 100644
--- a/drivers/net/phy/aquantia_main.c
+++ b/drivers/net/phy/aquantia_main.c
@@ -358,34 +358,50 @@ static int aqr107_read_rate(struct phy_device *phydev)
 	if (val < 0)
 		return val;
 
+	if (val & MDIO_AN_TX_VEND_STATUS1_FULL_DUPLEX)
+		phydev->duplex = DUPLEX_FULL;
+	else
+		phydev->duplex = DUPLEX_HALF;
+
 	switch (FIELD_GET(MDIO_AN_TX_VEND_STATUS1_RATE_MASK, val)) {
 	case MDIO_AN_TX_VEND_STATUS1_10BASET:
 		phydev->speed = SPEED_10;
+		config_reg = VEND1_GLOBAL_CFG_10M;
 		break;
 	case MDIO_AN_TX_VEND_STATUS1_100BASETX:
 		phydev->speed = SPEED_100;
+		config_reg = VEND1_GLOBAL_CFG_100M;
 		break;
 	case MDIO_AN_TX_VEND_STATUS1_1000BASET:
 		phydev->speed = SPEED_1000;
+		config_reg = VEND1_GLOBAL_CFG_1G;
 		break;
 	case MDIO_AN_TX_VEND_STATUS1_2500BASET:
 		phydev->speed = SPEED_2500;
+		config_reg = VEND1_GLOBAL_CFG_2_5G;
 		break;
 	case MDIO_AN_TX_VEND_STATUS1_5000BASET:
 		phydev->speed = SPEED_5000;
+		config_reg = VEND1_GLOBAL_CFG_5G;
 		break;
 	case MDIO_AN_TX_VEND_STATUS1_10GBASET:
 		phydev->speed = SPEED_10000;
+		config_reg = VEND1_GLOBAL_CFG_10G;
 		break;
 	default:
 		phydev->speed = SPEED_UNKNOWN;
-		break;
+		return 0;
 	}
 
-	if (val & MDIO_AN_TX_VEND_STATUS1_FULL_DUPLEX)
-		phydev->duplex = DUPLEX_FULL;
+	val = phy_read_mmd(phydev, MDIO_MMD_VEND1, config_reg);
+	if (val < 0)
+		return val;
+
+	if (FIELD_GET(VEND1_GLOBAL_CFG_RATE_ADAPT, val) ==
+	    VEND1_GLOBAL_CFG_RATE_ADAPT_PAUSE)
+		phydev->rate_adaptation = RATE_ADAPT_PAUSE;
 	else
-		phydev->duplex = DUPLEX_HALF;
+		phydev->rate_adaptation = RATE_ADAPT_NONE;
 
 	return 0;
 }
@@ -626,6 +642,16 @@ static void aqr107_link_change_notify(struct phy_device *phydev)
 		phydev_info(phydev, "Aquantia 1000Base-T2 mode active\n");
 }
 
+static int aqr107_get_rate_adaptation(struct phy_device *phydev,
+				      phy_interface_t iface)
+{
+	if (iface == PHY_INTERFACE_MODE_10GBASER ||
+	    iface == PHY_INTERFACE_MODE_2500BASEX ||
+	    iface == PHY_INTERFACE_MODE_NA)
+		return RATE_ADAPT_PAUSE;
+	return RATE_ADAPT_NONE;
+}
+
 static int aqr107_suspend(struct phy_device *phydev)
 {
 	return phy_set_bits_mmd(phydev, MDIO_MMD_VEND1, MDIO_CTRL1,
@@ -687,6 +713,7 @@ static struct phy_driver aqr_driver[] = {
 	PHY_ID_MATCH_MODEL(PHY_ID_AQR107),
 	.name		= "Aquantia AQR107",
 	.probe		= aqr107_probe,
+	.get_rate_adaptation = aqr107_get_rate_adaptation,
 	.config_init	= aqr107_config_init,
 	.config_aneg    = aqr_config_aneg,
 	.config_intr	= aqr_config_intr,
@@ -705,6 +732,7 @@ static struct phy_driver aqr_driver[] = {
 	PHY_ID_MATCH_MODEL(PHY_ID_AQCS109),
 	.name		= "Aquantia AQCS109",
 	.probe		= aqr107_probe,
+	.get_rate_adaptation = aqr107_get_rate_adaptation,
 	.config_init	= aqcs109_config_init,
 	.config_aneg    = aqr_config_aneg,
 	.config_intr	= aqr_config_intr,
@@ -731,6 +759,7 @@ static struct phy_driver aqr_driver[] = {
 	PHY_ID_MATCH_MODEL(PHY_ID_AQR113C),
 	.name           = "Aquantia AQR113C",
 	.probe          = aqr107_probe,
+	.get_rate_adaptation = aqr107_get_rate_adaptation,
 	.config_init    = aqr107_config_init,
 	.config_aneg    = aqr_config_aneg,
 	.config_intr    = aqr_config_intr,
-- 
2.35.1.1320.gc452695387.dirty