Re: [PATCHv2 5/7] KVM: SVM: Add VNMI support in inject_nmi

[Jim Mattson]

On Wed, Jul 20, 2022 at 2:41 PM Sean Christopherson <seanjc@xxxxxxxxxx> wrote:
>
> On Sat, Jul 09, 2022, Santosh Shukla wrote:
> > Inject the NMI by setting V_NMI in the VMCB interrupt control. processor
> > will clear V_NMI to acknowledge processing has started and will keep the
> > V_NMI_MASK set until the processor is done with processing the NMI event.
> >
> > Signed-off-by: Santosh Shukla <santosh.shukla@xxxxxxx>
> > ---
> > v2:
> > - Added WARN_ON check for vnmi pending.
> > - use `get_vnmi_vmcb` to get correct vmcb so to inject vnmi.
> >
> >  arch/x86/kvm/svm/svm.c | 10 +++++++++-
> >  1 file changed, 9 insertions(+), 1 deletion(-)
> >
> > diff --git a/arch/x86/kvm/svm/svm.c b/arch/x86/kvm/svm/svm.c
> > index 44c1f2317b45..c73a1809a7c7 100644
> > --- a/arch/x86/kvm/svm/svm.c
> > +++ b/arch/x86/kvm/svm/svm.c
> > @@ -3375,12 +3375,20 @@ static void pre_svm_run(struct kvm_vcpu *vcpu)
> >  static void svm_inject_nmi(struct kvm_vcpu *vcpu)
> >  {
> >       struct vcpu_svm *svm = to_svm(vcpu);
> > +     struct vmcb *vmcb = NULL;
> > +
> > +     ++vcpu->stat.nmi_injections;
> > +     if (is_vnmi_enabled(svm)) {
> > +             vmcb = get_vnmi_vmcb(svm);
> > +             WARN_ON(vmcb->control.int_ctl & V_NMI_PENDING);
>
> Haven't read the spec, but based on the changelog I assume the flag doesn't get
> cleared until the NMI is fully delivered.

Ooh! Is there a spec to read now?!?