Re: [PATCH V1 1/1] mmc:sdhci:Fix the SD tuning CMD parameter issue that the SDHCI_TRANSFER_MODE is cleared from read direction to write direction incorrectly

[Adrian Hunter]

On 20/07/22 15:37, Charl Liu wrote:
> When cmd->opcode == MMC_SEND_TUNING_BLOCK, the SDHCI_TRANSFER_MODE
> should also be kept
> 
> Signed-off-by: Charl Liu <charl.liu@xxxxxxxxxxxxxx>
> ---
> Change in V1:
> Keeping the SDHCI_TRANSFER_MODE when cmd->opcode == MMC_END_TUNING_
> BLOCK
> ---
>  drivers/mmc/host/sdhci.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
> index 22152029e14c..6a0f6725dadb 100644
> --- a/drivers/mmc/host/sdhci.c
> +++ b/drivers/mmc/host/sdhci.c
> @@ -1430,7 +1430,8 @@ static void sdhci_set_transfer_mode(struct sdhci_host *host,
>  		if (host->quirks2 &
>  			SDHCI_QUIRK2_CLEAR_TRANSFERMODE_REG_BEFORE_CMD) {
>  			/* must not clear SDHCI_TRANSFER_MODE when tuning */
> -			if (cmd->opcode != MMC_SEND_TUNING_BLOCK_HS200)
> +			if ((cmd->opcode != MMC_SEND_TUNING_BLOCK_HS200) &&
> +			(cmd->opcode != MMC_SEND_TUNING_BLOCK))

mmc_op_tuning() could be used here

>  				sdhci_writew(host, 0x0, SDHCI_TRANSFER_MODE);
>  		} else {
>  		/* clear Auto CMD settings for no data CMDs */