Re: [PATCH 0/2] PCI: mvebu: add support for orion soc

[Mauri Sandberg]

Hi Bjorn!

On 29.07.22 20:22, Bjorn Helgaas wrote:
> On Mon, Jul 18, 2022 at 11:28:40PM +0300, Mauri Sandberg wrote:
> > Hello all!
> >
> > Working in close co-operation with Pali we made an initial attempt at bringing
> > support for orion PCIe into mvebu PCIe driver. Currently the address of
> > workaround memory range is hard coded and based on compatible string only. As
> > Pali describes in another thread, we were not able to figure out what's the
> > correct way to configure a configuration space. That discussion is here:
> > https://lore.kernel.org/linux-pci/20220710225108.bgedria6igtqpz5l@pali/T/#u
> >
> > I tested this with D-Link DNS-323 rev A1 and it's working. As usual, all
> > comments and feedback is welcome.
> >
> > Thanks,
> > Mauri
> >
> > Mauri Sandberg (2):
> >    dt-bindings: PCI: mvebu: Add orion5x compatible
> >    PCI: mvebu: add support for orion5x
> >
> >   .../devicetree/bindings/pci/mvebu-pci.txt     |  1 +
> >   arch/arm/mach-orion5x/common.c                | 13 ----
> >   drivers/pci/controller/Kconfig                |  2 +-
> >   drivers/pci/controller/pci-mvebu.c            | 59 +++++++++++++++++++
> >   4 files changed, 61 insertions(+), 14 deletions(-)
>
> Hi Mauri,
>
> Can you address anything in 2/2 (if necessary), incorporate any acks,
> and post a v2?  There was some confusion around the first patch (there
> are two in the thread, likely the same?), and I didn't read the 2/2
> feedback in detail to see if any changes were needed.

I give it a little bit time to see if the discussion on how to configure
the configuration space would pick up, but I'll attend to the comments
and post a clean v2 soonish.