Re: [PATCH v2] dt-bindings: iio: gyroscope: bosch,bmg160: correct number of pins

From: Krzysztof Kozlowski
Date: Mon Aug 08 2022 - 01:48:42 EST


On 06/08/2022 16:32, Jonathan Cameron wrote:
> On Fri, 5 Aug 2022 09:55:03 +0200
> Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> wrote:
>
>> BMG160 has two interrupt pins to which interrupts can be freely mapped.
>> Correct the schema to express such case and fix warnings like:
>>
>> qcom/msm8916-alcatel-idol347.dtb: gyroscope@68: interrupts: [[97, 1], [98, 1]] is too long
>>
>> However the basic issue still persists - the interrupts should come in a
>> defined order.
>>
>> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
>>
>> ---
>>
>> Changes since v1:
>> 1. Accept also INT2 as one interrupt (Jonathan).
>
> This doesn't work. If we are going to support either interrupt, at the very least
> we need to require interrupt-names if the first one isn't INT1. So your fix
> is right but not enough.
>
> Driver may ignore interrupt-names for now (would be good to have a sanity check in driver
> though so the driver explicitly checks for INT2 and doesn't use the interrupt if
> it is INT2 - support for that being for a future 'feature' addition).
>
> A hacky solution would be to require the first one to always be INT1 but that
> gives us no (backwards compatible) path forwards if someone does have a board
> where only INT2 is wired.
>
> So minimum change I think will be to provide interrupt-names allowing any of
> INT1 (default if not specified)
> INT1, INT2
> INT2

This is exactly what my fix is doing. What else do you need?
interrupt-names is just a helper which anyway driver does not use, so
enforcing it now does not change much.


Best regards,
Krzysztof