[PATCH] Bluetooth: Honor name resolve evt regardless of discov state

[Archie Pusaka]

From: Archie Pusaka <apusaka@xxxxxxxxxxxx>

Currently, we don't update the name resolving cache when receiving
a name resolve event if the discovery phase is not in the resolving
stage.

However, if the user connect to a device while we are still resolving
remote name for another device, discovery will be stopped, and because
we are no longer in the discovery resolving phase, the corresponding
remote name event will be ignored, and thus the device being resolved
will stuck in NAME_PENDING state.

If discovery is then restarted and then stopped, this will cause us to
try cancelling the name resolve of the same device again, which is
incorrect and might upset the controller.

Signed-off-by: Archie Pusaka <apusaka@xxxxxxxxxxxx>
Reviewed-by: Ying Hsu <yinghsu@xxxxxxxxxxxx>

---
The following steps are performed:
    (1) Prepare 2 classic peer devices that needs RNR. Put device A
        closer to DUT and device B (much) farther from DUT.
    (2) Remove all cache and previous connection from DUT
    (3) Put both peers into pairing mode, then start scanning on DUT
    (4) After ~8 sec, turn off peer B.
    *This is done so DUT can discover peer B (discovery time is 10s),
    but it hasn't started RNR. Peer is turned off to buy us the max
    time in the RNR phase (5s).
    (5) Immediately as device A is shown on UI, click to connect.
    *We thus know that the DUT is in the RNR phase and trying to
    resolve the name of peer B when we initiate connection to peer A.
    (6) Forget peer A.
    (7) Restart scan and stop scan.
    *Before the CL, stop scan is broken because we will try to cancel
    a nonexistent RNR
    (8) Restart scan again. Observe DUT can scan normally.


 net/bluetooth/hci_event.c | 17 ++++++++++-------
 1 file changed, 10 insertions(+), 7 deletions(-)

diff --git a/net/bluetooth/hci_event.c b/net/bluetooth/hci_event.c
index 395c6479456f..95e145e278c9 100644
--- a/net/bluetooth/hci_event.c
+++ b/net/bluetooth/hci_event.c
@@ -2453,6 +2453,16 @@ static void hci_check_pending_name(struct hci_dev *hdev, struct hci_conn *conn,
 	    !test_and_set_bit(HCI_CONN_MGMT_CONNECTED, &conn->flags))
 		mgmt_device_connected(hdev, conn, name, name_len);
 
+	e = hci_inquiry_cache_lookup_resolve(hdev, bdaddr, NAME_PENDING);
+
+	if (e) {
+		list_del(&e->list);
+
+		e->name_state = name ? NAME_KNOWN : NAME_NOT_KNOWN;
+		mgmt_remote_name(hdev, bdaddr, ACL_LINK, 0x00, e->data.rssi,
+				 name, name_len);
+	}
+
 	if (discov->state == DISCOVERY_STOPPED)
 		return;
 
@@ -2462,7 +2472,6 @@ static void hci_check_pending_name(struct hci_dev *hdev, struct hci_conn *conn,
 	if (discov->state != DISCOVERY_RESOLVING)
 		return;
 
-	e = hci_inquiry_cache_lookup_resolve(hdev, bdaddr, NAME_PENDING);
 	/* If the device was not found in a list of found devices names of which
 	 * are pending. there is no need to continue resolving a next name as it
 	 * will be done upon receiving another Remote Name Request Complete
@@ -2470,12 +2479,6 @@ static void hci_check_pending_name(struct hci_dev *hdev, struct hci_conn *conn,
 	if (!e)
 		return;
 
-	list_del(&e->list);
-
-	e->name_state = name ? NAME_KNOWN : NAME_NOT_KNOWN;
-	mgmt_remote_name(hdev, bdaddr, ACL_LINK, 0x00, e->data.rssi,
-			 name, name_len);
-
 	if (hci_resolve_next_name(hdev))
 		return;
 
-- 
2.37.1.595.g718a3a8f04-goog