Re: [PATCH v2 2/9] KVM: x86: remove return value of kvm_vcpu_block

[Sean Christopherson]

On Thu, Aug 11, 2022, Paolo Bonzini wrote:
> The return value of kvm_vcpu_block will be repurposed soon to return

kvm_vcpu_block()

> the state of KVM_REQ_UNHALT.  In preparation for that, get rid of the
> current return value.  It is only used by kvm_vcpu_halt to decide whether

kvm_vcpu_halt()

> the call resulted in a wait, but the same effect can be obtained with
> a single round of polling.
> 
> No functional change intended, apart from practically indistinguishable
> changes to the polling behavior.

This "breaks" update_halt_poll_stats().  At the very least, it breaks the comment
that effectively says "waited" is set if and only if schedule() is called.

	/*
	 * Note, halt-polling is considered successful so long as the vCPU was
	 * never actually scheduled out, i.e. even if the wake event arrived
	 * after of the halt-polling loop itself, but before the full wait.
	 */
	if (do_halt_poll)
		update_halt_poll_stats(vcpu, start, poll_end, !waited);

> @@ -3493,35 +3489,32 @@ void kvm_vcpu_halt(struct kvm_vcpu *vcpu)
>  {
>  	bool halt_poll_allowed = !kvm_arch_no_poll(vcpu);
>  	bool do_halt_poll = halt_poll_allowed && vcpu->halt_poll_ns;
> -	ktime_t start, cur, poll_end;
> +	ktime_t start, cur, poll_end, stop;
>  	bool waited = false;
>  	u64 halt_ns;
>  
>  	start = cur = poll_end = ktime_get();
> -	if (do_halt_poll) {
> -		ktime_t stop = ktime_add_ns(start, vcpu->halt_poll_ns);
> +	stop = do_halt_poll ? start : ktime_add_ns(start, vcpu->halt_poll_ns);

This is inverted, the loop should terminate after the first iteration (stop==start)
if halt-polling is _not_ allowed, i.e. do_halt_poll is false.

Overall, I don't like this patch.  I don't necessarily hate it, but I definitely
don't like it.

Isn't freeing up the return from kvm_vcpu_check_block() unnecessary?  Can't we
just do:

diff --git a/arch/x86/kvm/x86.c b/arch/x86/kvm/x86.c
index 9f11b505cbee..ccb9f8bdeb18 100644
--- a/arch/x86/kvm/x86.c
+++ b/arch/x86/kvm/x86.c
@@ -10633,7 +10633,7 @@ static inline int vcpu_block(struct kvm_vcpu *vcpu)
                if (hv_timer)
                        kvm_lapic_switch_to_hv_timer(vcpu);

-               if (!kvm_check_request(KVM_REQ_UNHALT, vcpu))
+               if (!kvm_arch_vcpu_runnable(vcpu))
                        return 1;
        }


which IMO is more intuitive and doesn't require reworking halt-polling (again).

I don't see why KVM cares if a vCPU becomes runnable after detecting that something
else caused kvm_vcpu_check_block() to bail.  E.g. a pending signal doesn't invalidate
a pending vCPU event, and either way KVM is bailing from the run loop.