Re: [PATCH] watchdog: aspeed_wdt: Reorder output signal register configuration

[Guenter Roeck]

On Fri, Aug 19, 2022 at 05:49:05PM +0800, Chin-Ting Kuo wrote:
> If the output driving type is push-pull mode, the output
> polarity should be selected in advance. Otherwise, an unexpected
> value will be output at the moment of changing to push-pull mode.
> Thus, output polarity, WDT18[31], must be configured before
> changing driving type, WDT18[30].
> 
> Signed-off-by: Chin-Ting Kuo <chin-ting_kuo@xxxxxxxxxxxxxx>

Reviewed-by: Guenter Roeck <linux@xxxxxxxxxxxx>

> ---
>  drivers/watchdog/aspeed_wdt.c | 12 ++++++------
>  1 file changed, 6 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/watchdog/aspeed_wdt.c b/drivers/watchdog/aspeed_wdt.c
> index 436571b6fc79..a03e4ff812a2 100644
> --- a/drivers/watchdog/aspeed_wdt.c
> +++ b/drivers/watchdog/aspeed_wdt.c
> @@ -325,18 +325,18 @@ static int aspeed_wdt_probe(struct platform_device *pdev)
>  		u32 reg = readl(wdt->base + WDT_RESET_WIDTH);
>  
>  		reg &= config->ext_pulse_width_mask;
> -		if (of_property_read_bool(np, "aspeed,ext-push-pull"))
> -			reg |= WDT_PUSH_PULL_MAGIC;
> +		if (of_property_read_bool(np, "aspeed,ext-active-high"))
> +			reg |= WDT_ACTIVE_HIGH_MAGIC;
>  		else
> -			reg |= WDT_OPEN_DRAIN_MAGIC;
> +			reg |= WDT_ACTIVE_LOW_MAGIC;
>  
>  		writel(reg, wdt->base + WDT_RESET_WIDTH);
>  
>  		reg &= config->ext_pulse_width_mask;
> -		if (of_property_read_bool(np, "aspeed,ext-active-high"))
> -			reg |= WDT_ACTIVE_HIGH_MAGIC;
> +		if (of_property_read_bool(np, "aspeed,ext-push-pull"))
> +			reg |= WDT_PUSH_PULL_MAGIC;
>  		else
> -			reg |= WDT_ACTIVE_LOW_MAGIC;
> +			reg |= WDT_OPEN_DRAIN_MAGIC;
>  
>  		writel(reg, wdt->base + WDT_RESET_WIDTH);
>  	}
> -- 
> 2.25.1
>